Quick Clamp LW-STD
instructions manual
Universal & Fully Adjustable
Light-alloy Clamping Device
M5
M5 thread
1 2
Depending on the target tube
diameter, set the plastic shim in
the clamp.
Without Shim
Thin Shim
Thick Shim
Disassemble the clamp, wind
the arm around the target tube
then close both arms.
4 944924 33248 8
LW-STD
= 1-1/8"
= 1"
= 7/8"
Thick / Thin /
MINOURA CO.,LTD.
1197-1 Godo, Anpachi, Gifu
503-2305 Japan
3
4
Tighten the bolt with an M5 hex
wrench for firmly closing the clamp.
When tightening the bolt into
the pin, screw it with your
in the beginning. Use the
properly screw the bolt into
the thread.
Do not use any tool from the
beginning.
Make sure the thread hole on
the pin is aligned to the bolt
hole, then put into the holes.
The upper arms are so thin
that handle them carefully
not to bend.
Make sure the pin is stably
held with both upper arms.
Made in Japan
/