2. 車両
  3. 自動車アクセサリー
  4. オートバイの付属品
  5. Foxtech
  6. H-Wing PRO Vtol Dual Camera Mapping Combo
H-Wing PRO Vtol Dual Camera Mapping Combo

Foxtech H-Wing PRO Vtol Dual Camera Mapping Combo ユーザーガイド

  • H-Wing PRO ドローンのクイックスタートガイドの内容を読みましたので、このデバイスに関するご質問にお答えできます。このガイドには、バッテリーの充電方法、ドローンの組み立て方、飛行モードの切り替え方、そして安全なロック／アンロック方法などが記載されています。どのようなご質問でもお気軽にお尋ねください。
  • リモコンの電源のオン／オフ方法を教えてください。
    プロペラを装着する手順を教えてください。
    位置モードへの切り替え方法を教えてください。
    飛行機のロック／アンロック方法は？
    旋翼モードと固定翼モードの切り替え方法は？
H-Wing PRO
快速入门指南
Quick Start Guide
V2.1 2021.6
1充电 /Charging the Battery
请用 type-C 数据线链接您的充电头给遥控器充电。
Please connect your charger with a type-C data cable to charge the remote control.
2组装飞行器 /Assemble the drone
A- 逆时针拧紧
3安装螺旋桨 /Attaching the Propellers
B- 顺时针拧紧
黑桨帽
A-Tightencounterclockwise.
A
H-wing 机头方向
Aircraft head direction
B-Tightenclockwise.
B
白桨帽
Black nut propeller
标记 无标记 White nut propeller
Marked Unmarked
B A
4开启与关闭遥控器，安装飞行器电池 / Open and close the remote control,Install the battery
Long press to start/shut down.
飞行模式切换
Flight mode switch
左摇杆 右摇杆
Left Stick Right Stick
飞行姿态切换 飞行姿态切换
Flight attitude switch One-click return home
长按开机 / 关机。
20
AltitudeRotor Locked connected
Airspeed0.0m/sFlyingspeed0.0m/sAltitude
6摇杆操控飞行器 / Controlling the drone
美国手旋翼模式
American hand rotor mode
美国手固定翼模式
American hand fixed wing model
上升 / 下降
左转 / 右转
上升 / 下降
向左 / 向右
加速 / 减速
无
下降 / 爬升
左横滚 / 右横滚
Up/Down
Turn Left/Right
Forward/
Backward
Turn Left/
Right
Speed Up/
Slow down
Useless
Fall/Rise
Roll Left/
Roll Right
7位置模式 / Enter position mode
在户外空旷环境，遥控器向左拨杆等待飞行器进入位置模式。
In an open outdoor environment, move the remote control to the left and wait for the aircraft to enter the position mode.
定高模式
定高模式
位置模式
Altitude mode
Altitude mode
Position mode
8如何解锁（美国手）/ How to unlock(US hand)
进入位置模式后，油门杆最低，航向杆最右解锁飞行器。电机转动后，请马上松开摇杆。
After entering the position mode, the throttle stick is the lowest and the heading stick is the rightmost to unlock the
aircraft. After the motor rotates, please release the joystick immediately.
Altitude RotorLocked
20
co
nnected
100%
0.5 1 17 .4V
Altitude Rotor Locke d connect ed 20 100%
0.51 17.4V
Airspeed0.0m/sFly ings peed0.0m/s Al titude0.0 m
distance 0.0m/s Flight ti me00:00
升高飞机
Raise
水平地面
Level ground
旋翼模式下操作飞机升到 30 米高度即可按遥控A 按键切换为固定翼模式。
When operating the aircraft in rotor mode, you can press the
remote control A button to switch to fixed wing mode when you
reach 30 meters altitude.
Altitude Rotor cked 0.51 connect ed .4V
17
Airspeed0.0m /s Flying speed 0.0m
再按一次遥控器的A 按键，将切换回旋翼模式。
Press the A button on the remote control again to
switch to the rotor mode.
Altitude Rotor Locked 20
1
on
0
n
%
ec
0
c ted
Airspeed0.0m/sFly ing s peed 0.0m/s Altitude 0.0m/sHome tance
0.0m/sF li ght ti me0 0:0 0
降落
Landing
水平地面
Level ground
AltitudeRotorLocked connected
0 100%
0.51 17.4V
9旋翼切换固定翼模式 / Rotor switch fixed wing mode
10 如何上锁（美国手）/ How to lock (US hands)
飞行器降落在平地之后，将油门杆打到最低并保持几秒后电机停转。
After the aircraft lands on flat ground, hit the throttle stick to the lowest position and hold it for a few seconds before the
motor stops.
11 断开电源 / Disconnect the power
FCC Warning
15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be operated with minimum distance 20cm from the body.
IC Warning
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference;
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment should be operated with minimum distance 20cm from the body.
CE Warning
1.
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
2.
The operating temperature of the device can’t exceed 40℃and shouldn’t be lower than -20℃.
3.
The device complies with RF specifications when the device used at 20cm from the body.
Hereby, Shenzhen HEQ Intelligent Technology Co. LTD. declares that this product is in compliance with essential
requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU
member states.
/