If you turn the program selector knob to
another program when the machine is
working (except “Off” to switch off the
machine), symbol “ ” will flash on display
along with buzzer sound to indicate a wrong
selection. The machine will not perform the
new selected program.
16 www.zanussi.com
Press the option touchpads, if you want
your laundry to be washed with special
functions.
Different functions can be combined
which is dependent on the program
selected.
If you want to adjust washing time, press
the “Time Adjust ( )” touchpad repeatedly
to increase or decrease washing time. See
Time Adjust guide on page 12.
If you want to define the end of the washing
program, press the “Delay End ( )”
touchpad repeatedly to choose your
washing machine working time.
To pause, press Start/ Pause. The
indicator will start flashing.
-
Press the Start/Pause again. The
program will continue.
-
Changing a running program is possible
only by resetting it.
Turn the program selector knob to the
position “Off” to cancel the program
and to turn off the appliance.
-
5.5 Interruption Of A Program
5.6 Changing A Program
It may be possible to change some of the
options after a wash program has started.
Turn the program selector knob to the
new program position and change any
available options. Press Start/Pause
to start the new program.
The appliance will not drain the
water (except programs; Spin,
Rinse + Spin, Vapour Fresh).
-
5.7 Changing The Options
Press the touchpad Start/Pause. The
indicator will start flashing.
1.
If available change the options that
you wish.
2.
Press Start/Pause again. The program
will continue.
3.
If you want your laundry to be spun or use
temperature different from the one
proposed by the washing machine, pess
the Spin “ ” and the temperature “ ”
touchpads repeatedly to change the spin
speed and temperature.
5.3 Options Setting
1.
2.
If an option is not compatible with
the wash program selected, symbol
“ ” will flash on display along
with buzzer sound.
-
-
The appliance will automatically adjust the
selected program duration according to the
type and size of the load.
-
The display will show adjusted program
duration.
-
To start a program, press the Start/Pause
touchpad. The corresponding pilot light will
stop flashing and a default program duration
will be displayed on the screen.
5.4 Starting A Cycle ( )
After approx. 15 minutes from the
start of a program:
If you press any touchpad while a program
is operating, symbol “ ” will flash on
display along with buzzer sound. (except
Start/Pause touchpad)
-
-
While a program or the Delay End is
operating, the appliance door is locked
and the display shows the indicator “ ”.
First, set the machine to PAUSE by
pressing the “Start/Pause” touchpad. Wait
until the door lock indicator “ ” goes off,
then the door can be opened.
If the door lock indicator “ ” does not
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency please
refer to “Emergency door
opening” on page 27.
5.8 Opening The Door