2. Gigabyte
  3. GA-8I955X Royal
GA-8I955X Royal

Gigabyte GA-8I955X Royal インストールガイド

  • こんにちは！このGigabyteのマザーボード用Serial ATAハードドライブ構築マニュアルについて、ご質問にお答えします。このマニュアルでは、Sil3132チップセットを用いたSATAハードドライブのインストールからRAID設定、Windowsオペレーティングシステムのインストールまで、詳細な手順が説明されています。どのようなご質問でもお気軽にお尋ねください。
  • BIOSでSATAモードをRAIDに設定する必要があるのはなぜですか？
    SATAドライバをインストールしないとどうなるのですか？
    F6キーを押すタイミングはいつですか？
    RAID 0とRAID 1の違いは何ですか？
Serial ATA(Sil3132)...............................................................................2
(1)SATA................................................................................................................ 2
(2)BIOS SATA................................... 3
(3)RAID BIOSRAID................................................................................... 6
(4)SATA............................................ 10
(5)S A TA.......................................................... 12
Silicon Image Sil3132 SATA- 2 -
Ác
Åé
¤¤
¤å
Serial ATA(Sil3132)
SATA
(1)SATA
(2)BIOS SATA
(3)*RAID BIOSRAID
(4)SATA
(5)SATA
(a)S A TA(S A TA
RAID)
(b)
(c)Windows XP 2000
(d)
(1)SATA
SATA SATA
SATA(S A TA
)
"*"RAID
Silicon Image Sil3132 SATA- 3 -
1
(2)BIOS SATA
BIOS SATA
1
BIOS POST (Power-On Self Test)<Del>
BIOSCMOS SETUPIntegrated Peripherals
Onboard H/W SATAEnabledH/W SATA Function RAID
(1)RAIDH/W SATA Function BASE
BIOS
BIOS
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Integrated Peripherals
On-Chip Primary PCI IDE [Enabled]
On-Chip Secondary PCI IDE [Enabled]
SATA RAID/AHCI Mode [RAID]
xOn-Chip SATA Mode Auto
xPATA IDE Set to Ch.1 Master/Slave
SATA Port 0/2 Set to Ch.2 Master/Slave
SATA Port 1/3 Set to Ch.3 Master/Slave
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
Azalia Codec [Auto]
Onboard H/W 1394 [Enabled]
Onboard H/W SATA [Enabled]
H/W SATA Function [RAID]
Onboard H/W GigaRAID [Enabled]
GigaRAID Function [RAID]
Onboard H/W LAN1 [Enabled]
Onboard H/W LAN2 [Enabled]
higf: MoveEnter: Select+/-/PU/PD: ValueF10: SaveESC: Exit F1: General Help
F3: Language F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level}
If a hard disk
controller card is
used, set at Disabled.
[Enabled]
Enable on-chip IDE
Port.
[Disabled]
Disable on-chip IDE
Port.
Silicon Image Sil3132 SATA- 4 -
Ác
Åé
¤¤
¤å
2
Advanced BIOS Features Hard Disk
Boot PriorityMicrosoft Windows 2000/XP SATA(2)
2
RAID BIOS
(6)BIOSAdvanced
BIOS Features Hard Disk Boot PriorityMicrosoft Windows
2000/XP (3)
3
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Hard Disk Boot Priority
1. SCSI-0 : 05:00-0 SiI Raid0 Set
2. Bootable Add-in Cards
hi: Move PU/PD/+/-: Change Priority F10: Save ESC: Exit
Item Help
Menu Level }}
Use <h> or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Hard Disk Boot Priority
1. SCSI-0 : 05:00-0 ST3120026AS
2. SCSI-1 : 05:00-1 ST3120026AS
3. Bootable Add-in Cards
hi: Move PU/PD/+/-: Change Priority F10: Save ESC: Exit
Item Help
Menu Level }}
Use <h> or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
Silicon Image Sil3132 SATA- 5 -
3
First Boot Device CDROMCD -ROM(4)
4
BIOS
4
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Advanced BIOS Features
}Hard Disk Boot Priority [Press Enter]
First Boot Device [CDROM]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Password Check [Setup]
CPU Hyper-Threading # [Enabled]
Limit CPUID Max. to 3 [Disabled]
No-Execute Memory Protect (Note) [Enabled]
CPU Enhanced Halt (C1E) (Note) [Enabled]
CPU Thermal Monitor 2(TM2) (Note) [Enabled]
CPU EIST Function (Note) [Enabled]
DRAM Data Integrity Mode [Non-ECC]
higf: MoveEnter: Select+/-/PU/PD: ValueF10: SaveESC: Exit F1: General Help
F3: Language F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level}
Select Hard Disk Boot
Device Priority
Silicon Image Sil3132 SATA- 6 -
Ác
Åé
¤¤
¤å
(3)RAID BIOSRAID
SATARAID BIOS SATA RAID
RAID
1
BIOS POST (Power-On Self Test)
(5)<Ctrl>+<S> <F4>Sil3132 SATA RAID
5
6
SiI 3132 SATARaid BIOS Version 7.2.18
Copyright (C) 1997-2005 Silicon Image, Inc.
Press <Ctrl+S> or F4 to enter RAID utility_
RAID - RAID Configuration Utility(6)<h>
<i>
Create RAID set
Delete RAID set
Rubuild Raid1 set
Low Level Format
Logical Drive Info
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2005
Press "Enter" to create
RAID set
MAIN MENU HELP
hi: Select Menu ESC: Previous Menu Enter: Select Ctrl-E: Exit
0ST3120026AS 111GB
1ST3120026AS 111GB
PHYSICAL DRIVE
Reserved drives
LOGICAL DRIVE
Silicon Image Sil3132 SATA- 7 -
7
8
Create RAID set<Enter>RAID(7)
RAID<Enter>RAID0RAID1
SPARE DRIVE CONCATENATION RAID 0
RAID 0<Enter>(Auto configuration)
(Manual configuration)( 8)Striped size 64KB 0
1chunk size (4K128K)
Auto configuration
Manual configuration
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2005
Press "Enter" to automati-
cally create raid set
Striped size is 64KB
First drive is drive 0
MAIN MENU HELP
hi: Select Menu ESC: Previous Menu Enter: Select Ctrl-E: Exit
0ST3120026AS 111GB
1ST3120026AS 111GB
PHYSICAL DRIVE
Reserved drives
LOGICAL DRIVE
Create RAID set
Delete RAID set
Rubuild Raid1 set
Low Level Format
Logical Drive Info
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2005
RAID0=Striped
MAIN MENU HELP
hi: Select Menu ESC: Previous Menu Enter: Select Ctrl-E: Exit
0ST3120026AS 111GB
1ST3120026AS 111GB
PHYSICAL DRIVE
Reserved drives
LOGICAL DRIVE
RAID0
RAID1
SPARE DRIVE
CONCATENATION
Silicon Image Sil3132 SATA- 8 -
Ác
Åé
¤¤
¤å
9
10
<Enter>(9)
<h> < i>
<Enter>
"Are You Sure (Y/N)?"YN
LOGICAL DRIVE RAID
(10)
Create RAID set
Delete RAID set
Rubuild Raid1 set
Low Level Format
Logical Drive Info
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2005
Press "Enter" to create
RAID set
MAIN MENU HELP
hi: Select Menu ESC: Previous Menu Enter: Select Ctrl-E: Exit
0ST3120026AS 114473MB
1ST3120026AS 114473MB
PHYSICAL DRIVE
Sil Raid0 Set 181GB
LOGICAL DRIVE
Auto configuration
Manual configuration
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2005
Press "Enter" to select
the RaidSize
h: increment 1GB raid size
i: decrement 1GB raid size
MAIN MENU HELP
hi: Select Menu ESC: Previous Menu Enter: Select Ctrl-E: Exit
0ST3120026AS 111GB
1ST3120026AS 111GB
PHYSICAL DRIVE LOGICAL DRIVE
Please input the raid size: 181 GB
Reserved drives
Silicon Image Sil3132 SATA- 9 -
Delete RAID set<Enter>
(1 1 )
<Ctrl>+<E>RAID Co nfiguraion Utility
Create RAID set
Delete RAID set
Rubuild Raid1 set
Low Level Format
Logical Drive Info
RAID Configuration Utility - Silicon Image Inc. Copyright (C) 2005
Press "Enter" to delete
a RAID set
MAIN MENU HELP
hi: Select Menu ESC: Previous Menu Enter: Select Ctrl-E: Exit
0ST3120026AS 114473MB
1ST3120026AS 114473MB
PHYSICAL DRIVE
Sil Raid0 Set 181GB
LOGICAL DRIVE
11
Silicon Image Sil3132 SATA- 10 -
Ác
Åé
¤¤
¤å
11
(4)SATA
Microsoft Windows 2000/XP SATA
S A TA
SATA
1
2
(1 2 )
13
BootDrv
MENU.EXE (13)
12
Silicon Image Sil3132 SATA- 11 -
3
MENU.EXE MS-DOS(14)
16
14
4
SATA SATA
1 5
Sil31 32 A A)Si3132 RAID Driver
Sil31 32 9)Si3132 BASE Driver
S A TA
5
(16)0
15
Silicon Image Sil3132 SATA- 12 -
Ác
Åé
¤¤
¤å
17
Windows Setup
Press F6 if you need to install a 3rd party SCSI or RAID driver.
(5)SATA
S A TA B IOS
Microsoft Windows 2000 XP SATA(Microsoft
Windows XP )
1
Microsoft Windows 2000 X P
Press F6 if you need to install a 3rd party SCSI or RAID driver
<F6>(1 7 )<F6>
1 8 < F 6 > 1
2
SATA<S>(1 8 )
18
Windows Setup
S=Specify Additional Device ENTER=Continue F3=Exit
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices(s)
<none>
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Silicon Image Sil3132 SATA- 13 -
3
(19)
Windows XP Silicon Image SiI 3132 SoftRAID 5 Controller for Windows XP/Server
2003( ) <Enter>
19
SATA
20
Windows Setup
ENTER=Select F3=Exit
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
Silicon Image SiI 3132 SoftRAID 5 Controller for Windows XP/Server 2003
Silicon Image SiI 3132 SoftRAID 5 Controller for Windows 2000
( ) RAIDSilicon Image SiI 3132 SATALink Controller for Win
dows XP/Server 2003 Silicon Image SiI 3132 SATALink Controller for Windows 2000
(2 0 )<ENTER>
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
Setup will load support for the following mass storage device(s):
Silicon Image SiI 3132 SoftRAID 5 Controller for Windows XP/Server 2003
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Silicon Image Sil3132 SATA- 14 -
Ác
Åé
¤¤
¤å
S A TA(21)<ENTER>
Microsoft Windows 20 00 XP
21
WindowsXP Professional
l Windows XP ENTER
l , C
l , D
ENTER= C=F3=
114471 MB Disk 0 at Id 16 on bus 0 on Si3132r5 (MBR)
114471MB
/