•
•
1.
2.
3.
4.
©
•
•
•
OP-C30DP01 OP-C30DP02
OP-C30DP
40785256 2PD
Replacing the decorative panels
•
The shiny side is the “outer side.” Insert the panels so that the “outer side” is facing the outside.
•
Insert the decorative panels in the orientation shown below.
* If the main unit is already attached to the stand, you’ll need to
separate the main unit from the stand.
After you replace the decorative panel, place the main unit back on
the stand and tighten the knob bolts.
1.
Bend the decorative panel so that the stopper attached to it
is freed from the bracket, and pull the decorative panel
upward and out of the side board.
2.
Remove the stopper from the decorative panel, and attach
it to the other decorative panel that you’ll be installing.
* Carefully observe the upward/downward orientation of the
decorative panel, and attach the stopper to the middle of the top
edge of the decorative panel as shown in the illustration.
* You must attach the stoppers to the decorative panels.
3.
With the decorative panel positioned so that its shiny side
(outer surface) is facing outward, slide it into the grooves
of the side board and gently lower it into position.
4.
When the stopper attached to the decorative panel contacts
the bracket, press the stopper downward to push the
decorative panel into place.
• Do not apply excessive force to any part. Doing so may cause deformation or damage.
• Be careful not to pinch your hands or drop anything on your feet.
• Should you remove the stoppers, keep them in a safe place out of children’s reach, so there is no chance of them being
swallowed accidentally.
About the decorative panels
Procedure
To p
Bottom
Away
from
yourself
Toward
yourself
To p
Bottom
Away
from
yourself
OP-C30DP01
To p
Bottom
Away
from
yourself
To p
Bottom
Toward
yourself
Away
from
yourself
OP-C30DP02
To p
Bottom
Toward
yourself
Away
from
yourself
(Outer side) (Outer side)
Stopper
Bracket
Stopper
Stopper
Copyright © 2008 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any
form without the written permission of ROLAND CORPORATION.
OP-C30DP
40785256 2PD
-
1
-
2
