BG3005/15
ENGLISH
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benet from the support that Philips
oers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
1 Trimming comb(3mm/ 1/8in.)
2 Shaving unit
3 Shaving foil
4 On/o button
5 Battery status light
6 Supply unit
7 Small plug
Important safety information
Read this important information carefully before you
use the appliance and its accessories and save it for
future reference. The accessories supplied may vary
for dierent products.
Danger
-Keep the supply unit dry.
Warning
-To charge the battery, only use the detachable
supply unit (HQ850) provided with the
-appliance.
-The supply unit contains a transformer. Do not
cut o the supply unit to replace it with another
plug, as this causes a hazardous situation.
-This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children without supervision.
-Always unplug the appliance before you clean it
under the tap.
-Always check the appliance before you use it. Do
not use the appliance if it is damaged, as this may
cause injury. Always replace a damaged part with
one of the original type.
-Do not open the appliance to replace the
rechargeable battery.
Caution
-Never immerse the charging stand in water and
do not rinse it under the tap.
-Do not use the supply unit in or near wall sockets
that contain an electric air freshener to prevent
irreparable damage to the supply unit.
-Only use this appliance for its intended purpose
as shown in the user manual.
-For hygienic reasons, the appliance should only
be used by one person.
-Never use water hotter than 60°C to rinse the
appliance.
-Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic elds.
General
-This appliance is waterproof. It is suitable for use
in the bath or shower and for cleaning under
the tap. For safety reasons, the appliance can
therefore only be used without cord.
-The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
-The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Charging
Battery status indications
-When the battery is almost empty, the battery
status indicator ashes orange (Fig. 2).
-When the appliance is charging, the battery status
indicator ashes green (Fig. 3).
-When the battery is fully charged, the battery
status indicator lights up green continuously.
Note: After approx. 30 minutes, the light goes out
automatically.
Charging
Charging takes approx. 8 hours. Charge the
appliance before you use it for the rst time and
when the display indicates that the battery is almost
empty.
-Charging, recharging or using the product at
temperatures below 40°F (4,5°C) or higher than
95°F (35°C) adversely aects the lifespan of the
battery.
-If the appliance is subjected to a major change
in temperature, pressure or humidity, let the
appliance acclimatise for 30 minutes before you
use it.
1 Make sure the appliance is switched o.
2 Insert the small plug into the shaver and put the
supply unit in the wall socket (Fig. 3)
3 After charging, remove the supply unit from the
wall outlet and pull the small plug out of the
appliance.
Operating time BG3005
When the appliance is fully charged, it has a cordless
operating time of up to 40 minutes.
Using the appliance
You can use the appliance wet or dry to shave hair
on all parts of your body below the neckline (Fig. 5),
(Fig. 6).
Always check the appliance and all accessories
before you use them. Do not use the appliance or
any accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one of
the original type.
- Use this appliance for its intended household use
as described in this manual.
- For hygienic reasons, the appliance should only be
used by one person.
- Trimming is easier when the skin and hair are dry
Note: This appliance is for cordless use only.
Switching the appliance on and o
1 Press the on/o button once to switch the
appliance on or o (Fig. 7).
Attaching and detaching combs
1 To attach a comb, snap the front part of the
comb onto the teeth of the shaving unit and push
the projection at the back of the comb into the
appliance ('click') (Fig. 8).
2 To detach a comb, carefully pull the back part
o the appliance and then remove it from the
shaving unit (Fig. 9).
Trimming
Trimming
1 Snap the trimming comb onto the appliance
(Fig. 8).
2 Press the on/o button to turn on the appliance
(Fig. 7).
3 Move the appliance against the direction of hair
growth (Fig. 11), (Fig. 12).
Note: Make sure that the at part of the trimming
guard is always fully in contact with the skin.
4 Switch o and clean the appliance after each use
(see 'Cleaning').
- If you are trimming for the rst time, be careful.
Do not move the appliance too fast. Make
smooth and gentle movements
- Since all hairs do not grow in the same
direction, you may want to try dierent trimming
positions (i.e. upwards, downwards, or across).
Practice is best for optimum results.
- Always make smooth and gentle movements
and be sure the surface of the comb always stays
in contact with your skin.
- Body hair can be trimmed wet or dry, however
dry is preferable because wet hair tends to stick
to the body.“
- When trimming sensitive areas, always use a
trimming comb.
Trimming length settings
The trimming comb allows you to cut hair to a length
of 3 mm (1/8 in.)
Shaving
This product is only intended for shaving and
trimming body parts below the neckline. Do not use
it to shave or trim facial or scalp hair.
-When shaving sensitive areas for the rst time,
you may experience some discomfort, irritation or
reddening of the skin. This is normal as your skin
needs time to adjust to shaving.
-If your hair is longer than 10mm, trim hair to a
length of 3mm rst for optimum shaving results.
-For dry use, make sure that your skin is clean and
dry before using the shaving unit.
-For wet use, prepare your skin with lathered soap
or shaving foam before you use the appliance.
1 Remove any trimming comb from the appliance
(Fig. 9).
2 Press the on/o button to switch on the
appliance (Fig. 7).
3 Stretch your skin taut with your free hand (Fig. 13).
Gently press the shaving unit onto skin and move
it slowly and smoothly against the direction of
hair growth (Fig. 14), (Fig. 15).
-Do not press too hard. Too much pressure can
distort the foil and cause skin irritation.
-Make sure the shaving unit is always in full
contact with your skin.
-The shaver is bi-directional, which means that
you can shave by moving the appliance up and
down. Shave against the hair growth for optimal
performance.
4 Switch o and clean the appliance after each use
(see 'Cleaning').
Cleaning
Clean the appliance after every use.
Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean
the appliance.
Never dry trimmer or shaving foil head with a towel,
brush or tissue, as this may cause damage.
1 switch o the appliance (Fig. 7).
2 Remove any trimming comb from the appliance
(Fig. 9).
3 Remove the shaving unit by pulling it o the
appliance (Fig. 16).
-Hold the shaving foil head by the plastic housing
only.
4 Rinse the shaving foil head with warm running
tap water (Fig. 17).
5 Allow the shaving unit to air dry completely.
-Never dry trimmer or shaving foil head with a
towel, brush or tissue, as this may cause damage.
6 Rinse the hair chamber under warm running tap
water to remove any residues (Fig. 18).
7 Reattach the shaving unit by snapping it back
onto the appliance (Fig. 19). ('click')
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your Philips
dealer. You can also contact the Philips Consumer
Care Center in your country (see the international
warranty leaet for contact details).
- Model TT2000 Philips replacement shaving unit.
Replacement
Replacing the shaving foil head
For maximum shaving performance, we advise you
to replace the shaving unit every year (TT2000). If
the shaving unit is worn or damaged, do not use the
appliance and replace the shaving unit immediately.
Always replace the shaving unit with original Philips
TT2000 shaving unit. Accessories (Fig. 20).
1 Switch o the appliance and disconnect it from
the wall socket (Fig. 7).
2 Pull the shaving unit out of the appliance (Fig. 16).
Note: The foil is delicate. Handle the shaving unit
with care.
3 Snap the new shaving unit into the appliance
('Click') (Fig. 19).
4 Check if the shaving unit is rmly attached before
you use the appliance.
Recycling
-This symbol means that this product shall not
be disposed of with normal household waste
(2012/19/EU).
-This symbol means that this product contains
a built-in rechargeable battery which shall not
be disposed of with normal household waste
(2006/66/EC). Please take your product to an
ocial collection point or a Philips service center
to have a professional remove the rechargeable
battery.
-Follow your country’s rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when
you discard the product. Before you remove
the battery, make sure that the product is
disconnected from the wall socket and that the
battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the product and when
you dispose of the rechargeable battery.
1 Place a athead screwdriver in the hole above the
socket for the small plug. Twist the screwdriver to
create a gap between the front and back panel of
the appliance (Fig. 21).
2 Place a athead screwdriver between the front
and back panel. Twist the screwdriver to remove
front panel of the appliance (Fig. 22)
3 Place a athead screwdriver between the inner
body and the back panel. Twist the screwdriver to
remove the back panel of the appliance (Fig. 23).
4 Remove the two screws in the back of the
appliance (Fig. 24).
5 Pull the panel with the on-o button from the
inner body (Fig. 25).
6 Remove the transparent inner cover by bending
the transparent aps away from the hooks (Fig.
26).
7 Pull the printed circuit board o the inner body
(Fig. 27)
8 Cut the wires that connect the batteries to the
printed circuit board and remove the batteries
(Fig. 28).
Warranty and support
If you need information or support, please visit
www.philips.com/support or read the international
warranty leaet.
Warranty restrictions
Cutting units are not covered by the terms of the
international warranty because they are subject to
wear.
12M
3mm
1/8in.
1
23
4
5
7
6
BG3005-15_cs6_190208.indd 2 19/02/08 14:13