Dante LCD monitor manual
5
1. Remote controller buttons function introduction
(1)“Power” If monitor is working, press power button to turn the monitor off
and go standby.
(2)“Mute” button:Press this button, sounds will disappear, press again, it
will be back.
(3)Move forward/back, used for adjust specification.
(4)“UP/down:press these each two button, specification will roll up/down.
(5)“Exit” can exit directly from menu。
(6)“Menu” Press this button, main menu will come out. Press again then
can exit main menu
(7)“Source”press and choose the signal options, with up/down to adjust.
2. Caution
(1)With seven mode AAA1,5V battery,keep the battery’s positive and
negative charges are same with the indication of the controller
(2)If remote controller doesent’s work for a long time, please take out the
batteries to avoid damaging the controller.
(3)Do not dismantle the controller
(4)Keep away from heat source