GC-CI22M_A
GC-CI11M_A
Installation Guide/
/
12WE6-WIFICNV-10*R
- 2 -
Intel® CNVi interface 802.11a/b/g/n/ac, supporting 2.4/5 GHz Dual-Band
(M.2 Socket 1, type 2230)
Bluetooth 5
Support for 11ac 160MHz wireless standard and up to 1.73 Gbps data rate
* Actual data rate may vary depending on environment and equipment.
Intel® CNVi interface 802.11a/b/g/n/ac 2.4/5 GHz
(M.2 Socket 1, type 2230)
Bluetooth 5
11ac 160MHz 1.73 Gbps
*
Intel® CNVi interface 802.11a/b/g/n/ac 2.4/5 GHz
(M.2 Socket 1, type 2230)
Bluetooth 5
11ac 160MHz 1.73 Gbps
*
Intel® CNVi interface 802.11 a/b/g/n/ac 2.4 GHz 5 GHz
(M.2 Socket 1, type 2230)
Bluetooth 5
11ac 160MHz 1.73 Gbps
*
GC-CI22M_A
Intel® Wireless-AC 9560
- 3 -
Intel® CNVi interface 802.11a/b/g/n/ac, supporting 2.4/5 GHz Dual-Band
(M.2 Socket 1, type 2230)
Bluetooth 5
Support for 11ac wireless standard and up to 433 Mbps data rate
* Actual data rate may vary depending on environment and equipment.
Intel® CNVi interface 802.11a/b/g/n/ac 2.4/5 GHz
(M.2 Socket 1, type 2230)
Bluetooth 5
11ac 433 Mbps
*
Intel® CNVi interface 802.11a/b/g/n/ac 2.4/5 GHz
(M.2 Socket 1, type 2230)
Bluetooth 5
11ac 433 Mbps
*
Intel® CNVi interface 802.11 a/b/g/n/ac 2.4 GHz 5 GHz
(M.2 Socket 1, type 2230)
Bluetooth 5
11ac 433 Mbps
*
GC-CI11M_A
Intel® Wireless-AC 9462
- 4 -
Antenna Connector
M.2 Wi-Fi Module
M.2 Wi-Fi
M.2 Wi-Fi
M.2 Wi-Fi
Antenna •
•
Installing the M.2 Wi-Fi Module • M.2 Wi-Fi
M.2 Wi-Fi • M.2 Wi-Fi
- 5 -
Step 2:
Press the M.2 Wi-Fi module down and then secure
it with the screw.
M .2 Wi-Fi
M.2 Wi-Fi
2
M.2 Wi-Fi
Step 1:
Unfasten the screw from the motherboard. Insert
the M.2 Wi-Fi module into the M.2 Wi-Fi connector.
M.2 Wi-Fi
M.2 Wi-Fi M.2 Wi-Fi
M.2 Wi-Fi
M.2 Wi-Fi M.2 Wi-Fi
1
M.2 Wi-Fi M.2 Wi-Fi
- 6 -
Step 3:
Secure the metal bracket to the chassis back panel
with a screw. Tighten the antenna cables to the
antenna connectors.
M.2 Wi-Fi
M.2 Wi-Fi
3
Step 4:
Then move the antenna to a place where the
signal is good.
4
- 7 -
After the computer starts, install the driver for the Wi-Fi module. Adjust your wireless LAN
configuration based on your environment after installing the driver.
L AN
Installing the Drivers and Utilities •
•
- 8 -
FCC Notice (U.S.A. Only)
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates and radiates radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult a dealer or experienced TV/radio technician for help.
The user may find the following booklet prepared by the Federal Communications Commission helpful:
The Interference Handbook.
This booklet is available from the U.S. Government Printing Office, Washington, D.C.20402. Stock
No.004-000-00345-4
Notice for 5GHz
Operations in the 5.15-5.25GHz band are restricted to indoor usage only. (For 5GHz only)
RF exposure statement
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and
are safe for intended operation as described in this manual. The further RF exposure reduction can be
achieved if the product can be kept as far as possible from the user body or set the device to lower output
power if such function is available.
CAUTION:
The manufacturer is not responsible for any interference caused by unauthorized
modifications and/or use of unauthorized antennas.
Such changes and/or modifications not expressly approved by the party responsible for
compliance of this device could void the user's authority to operate the equipment.
- 9 -
Canada-Industry Canada (IC):
This device complies with Canadian RSS-210.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux appareils radio exempts de licence.
Son fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement
indésirable.
Notice for 5GHz:
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply
with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits
specified for point-to-point and non point-to-point operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions
susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés uniquement pour une utilisation à l’intérieur
afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5 250-5 350 MHz et 5 470-5 725 MHz
doit se conformer à la limite de p.i.r.e.;
(iii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande 5 725-5 825 MHz) doit se conformer à la
limite de p.i.r.e. spécifiée pour l’exploitation point à point et non point à point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés
utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que
ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled environment and are safe
for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower output power if such function is available.
- 10 -
European Community Radio Equipment Directive (RED) Compliance Statement:
This equipment complies with all the requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU.
This equipment is suitable for home and office use in all the European Community Member States and EFTA Member States.
The low band 5.15 -5.35 GHz is for indoor use only.
Restrictions d’utilisation en France:
Pour la France métropolitaine
2.400 - 2.4835 GHz (Canaux 1à 13) autorisé en usage intérieur
2.400 - 2.454 GHz (canaux 1 à 7) autorisé en usage extérieur
Pour la Guyane et la Réunion
2.400 - 2.4835 GHz (Canaux 1à 13) autorisé en usage intérieur
2.420 - 2.4835 GHz (canaux 5 à 13) autorisé en usage extérieur
Notice for Italy:
The use of these equipments is regulated by:
1. D.L.gs 1.8.2003, n. 259, article 104 (activity subject to general authorization) for outdoor use and article 105 (free
use) for indoor use, in both cases for private use.
2. D.M. 28.5.03, for supply to public of RLAN access to networks and telecom services. L’uso degli apparati è
regolamentato da:
1. D.L.gs 1.8.2003, n. 259, articoli 104 (attività soggette ad autorizzazione generale) se utilizzati al di fuori del proprio
fondo e 105 (libero uso) se utilizzati entro il proprio fondo, in entrambi i casi per uso private.
2. D.M. 28.5.03, per la fornitura al pubblico dell’accesso R-LAN alle reti e ai servizi di telecomunicazioni.
Taiwan NCC Wireless Statements / :
低功率電波輻射性電機管理辦法
第十二條: 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、
加大功率或變更原設計之特性及功能。
第十四條: 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即
停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通
信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
在5.25-5.35秭赫頻帶內操作之無線資訊傳輸設備，限於室內使用。
Korea KCC NCC Wireless Statement:
5,25 GHz - 5,35 GHz 대역을 사용하는 무선 장치는 실내에서만 사용하도록 제한됩니다。
Japan Wireless Statement:
5.15GHz帯 ~ 5.35GHz帯: 屋内のみの使用。
- 11 -
- 12 -
PCIe add-in card
GC-CI22M_A
GC-CI11M_A
Feb. 9, 2018
PCIe add-in card
GC-CI22M_A
GC-CI11M_A
Feb. 9, 2018
- 13 -
GC-CI22M_A
Wireless Module Country Approvals:
Radio Equipment:
Name: Intel® Wireless-AC 9560
Model: 9560NGW
Manufacturer: Intel Mobile Communications SAS
- 14 -
GC-CI11M_A
Wireless Module Country Approvals:
Radio Equipment:
Name: Intel® Wireless-AC 9462
Model: 9462NGW
Manufacturer: Intel Mobile Communications SAS
•All brand names and products are registered trademarks of their respective companies.
•Wi-Fi
®
is a registered trademark of Wi-Fi Alliance.
•Bluetooth
®
is a registered trademark of Bluetooth SIG, Inc.
•All product, company and technical standards names are trademarks
™
or registered
®
trademarks of their respective holders.
Use of these names does not imply any affiliation with or endorsement of GIGABYTE.
/