HP xw8600 Workstation インストールガイド

タイプ
インストールガイド

このマニュアルも適しています

3. シ背面の適切拡張 バー
コンピュータ マニュアルを参がら、
カバーを取ます
4. お使いの ルの
必要があ 場合は、 ルハ ブラケッ
梱の プロフイル ブラケッ り替
5. の背面の空い
の位置に合わせ 固定
テム ボー の拡張 込み1
6. カー4 電源 利用可能 ー電源
ブルに接続ます2 ー電源ルがい場合は、
標準サズの電源 の電源 の間に
売のY字型 ケーブルを取付けま
注:一部のデルは、 パネルの1394ポー
トからカードの10ピン1394コネクタに続しま
7. お使いのモデル ニズムで、 拡張
ロッ カバーを固定します
マニルを参
8. ュータのカバを装着しなおて、電源コ を接
なおます
9. 1394デバ ポー に接続
10. の電源入れす。 システム
が認識 自動的 バが
スト
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio or television
technician for help.
Modifications
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly approved by
Hewlett Packard Company may void the user's authority to operate the
equipment.
Cables
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods in order to maintain compliance with
FCC Rules and Regulations.
Declaration of Conformity for Products Marked
with FCC Logo, United States Only
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
For questions regarding your product, contact:
Hewlett Packard Company
P. O. Box 692000, Mail Stop 530113
Houston, Texas 77269-2000
Or, call 1-800-HP-INVENT (1-800-474-6836)
For questions regarding this FCC declaration, contact:
Hewlett Packard Company
P. O. Box 692000, Mail Stop 510101
Houston, Texas 77269-2000
Or, call (281) 514-3333
To identify this product, refer to the Part, Series, or Model number found
on the product.
Canadian Notice
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Avis Canadien
Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
European Union Notice
This product complies with the following EU Directives:
Low Voltage Directive 73/23/EEC
EMC Directive 89/336/EEC
Compliance with these directives implies conformity to applicable
harmonized European standards (European Norms) which are listed on
the EU Declaration of Conformity issued by Hewlett-Packard for this
product or product family.
This compliance is indicated by the following conformity marking
placed on the product:
Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034
Boeblingen, Germany
Japanese Notice
Korean Notice
XXXX*
This marking is valid for non-
Telecom products and EU
harmonized Telecom products
(e.g. Bluetooth)
This marking is valid for EU non-harmonized
Telecom products.
*Notified body number (used only if
applicable - refer to the product label)
349499-395.fm 2 ページ 2006年10月27日 金曜日 午前11時30分
  • Page 1 1
  • Page 2 2

HP xw8600 Workstation インストールガイド

タイプ
インストールガイド
このマニュアルも適しています

他の言語で