HQ6075, HQ6073, HQ6070

1

2

3

4

5 6

7 8

9

10

19

ENGLISH

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

This appliance is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

The powerplug contains a transformer. Do not cut

off the powerplug to replace it with another plug, as

this causes a hazardous situation.

Do not use a damaged powerplug.

If the powerplug is damaged, always have it replaced

with one of the original type in order to avoid a

hazard.

Charge and store the shaver at a temperature

between 5°C and 35°C.

Do not recharge the shaver in a closed pouch.

Be careful with hot water. Always check if the water is not

too hot, to prevent your hands from getting burnt.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientic

evidence available today.

Charging

Make sure the appliance is switched off before you start

Do not leave the appliance connected to the mains for

more than 24 hours.

Charge indications

Charging

When you start charging the empty shaver the

battery symbol lights up (Fig. 2).

Battery running low

HQ6075/HQ6073: When the battery is running low,

the red battery symbol starts burning. When you

switch off the shaver, the red battery symbol starts

or ashes (HQ6075/HQ6073) or when the motor stops

or starts running slower (HQ6070).

1 Put the appliance plug in the shaver (Fig. 3).

2 Put the powerplug in the wall socket.

3 Remove the powerplug from the wall socket and

pull the appliance plug out of the shaver when the

battery has been fully charged.

Cordless shaving time

A fully charged shaver has a cordless shaving time of up

to 40 minutes.

-

-

-

-

-

-

,

,

making both straight and circular

movements (Fig. 4).

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get accustomed to

the Philips shaving system.

3 Press the on/off button once to switch on the

shaver.

4 Put the protection cap on the shaver every time

you have used it, to prevent damage (Fig. 5).

Trimming

The easiest and most hygienic way to clean the appliance

is to rinse the shaving unit and the hair chamber with hot

water every time you have used the appliance.

Be careful with hot water. Always check if the water is

not too hot, to prevent your hands from getting burnt.

Every day: shaving unit and hair chamber

1 Switch off the shaver, remove the powerplug from

the wall socket and pull the appliance plug out of

the shaver.

2 Press the release button (1) and open the shaving

5 Close the shaving unit and shake off excess water.

Never dry the shaving unit with a towel or tissue, as

this may damage the shaving heads.

6 Open the shaving unit again and leave it open to let

the appliance dry completely (Fig. 10).

You can also clean the hair chamber without water by

using the brush supplied.

Every six months: shaving heads

1 Open the shaving unit and pull it off the shaver.

You can also leave the shaving unit attached to the shaver.

one shown in the gure) (Fig. 13).

Do not clean more than one cutter and guard at a time,

since they are all matching sets. If you accidentally mix up

the cutters and guards, it may take several weeks before

optimal shaving performance is restored.

5 HQ6075: Put the shaving heads back into the

shaving unit and then put the retaining frame back

into the shaving unit (Fig. 14).

Make sure that the projections of the shaving heads t

into the recesses.