Philips AT800/16 ユーザーマニュアル

カテゴリー
メンズシェーバー
タイプ
ユーザーマニュアル
Question?
有疑问?
Contact Philips
请联系飞利浦
AT80 0
1
AT800
ENGLISH 6
简体中文 21
6
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benet from the support that Philips
offers, register your product at www.philips.com/
welcome.
Please read this user manual, as it contains information
about the wonderful features of this shaver as well as
some tips to make shaving easier and more enjoyable.
General description (Fig. 1)
1 Protection cap
2 Shaving unit
3 Shaving unit release button
4 Shaver on/off button
5 Charging light
6 Charging stand
7 Adapter
8 Cleaning brush
9 Trimmer release slide
10 Trimmer
Important safety information
Read this important information carefully before you
use the appliance and its accessories and save it for
future reference. The accessories supplied may vary
for different products.
Danger
- Keep the adapter dry.
- This symbol means: Forbidden to clean under a
running tap.
ENGLISH
Warning
- The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug,
as this causes a hazardous situation.
- This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
- Children should be supervised to ensure that they
do not play with the appliance.
- Always unplug the shaver before you clean it
under the tap.
- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as this
may cause injury. Always replace a damaged part
with one of the original type.
Caution
- Never use water hotter than 80°C to rinse the shaver.
- Only use this appliance for its intended purpose as
shown in the user manual.
- For hygienic reasons, the appliance should only be
used by one person.
- Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as petrol
or acetone to clean the appliance.
- Water may drip from the socket at the bottom
of the shaver when you rinse it. This is normal
and not dangerous because all electronics are
enclosed in a sealed power unit inside the shaver.
Electromagnetic elds (EMF)
- This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic elds.
ENGLISH 7
General
- This symbol means: Suitable to be used in the shower.
- This shaver is waterproof. It is suitable for use in
the bath or shower and for cleaning under the tap.
For safety reasons, the shaver can therefore only
be used without cord.
- The appliance is suitable for mains voltages ranging
from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
Charging
Note: The shaver cannot be used directly from the mains.
It takes approx. 1 hour to fully charge the shaver.
When you charge the shaver for the rst time or
after a long period of disuse, let it charge until the
charging light lights up continuously.
A fully charged shaver provides up to 50 minutes of
shaving time.
The shaving time may be less than 50 minutes as
a result of your shaving behaviour, your cleaning
habits or your beard type.
Charge indications
Battery low
- When the battery is almost empty (when there
are only 5 or fewer shaving minutes left),
the charging light starts to ash orange.
- When you switch off the shaver, the charging light
continues to ash orange for a few seconds.
ENGLISH8
Quick charging
- When you start charging the empty battery,
the charging light alternately ashes orange and
green. After approx. 3 minutes the charging light
continues to ash green. The shaver now contains
enough energy for a 5-minute shave.
Charging
- When the shaver is charging, the charging light
ashes green.
Battery fully charged
- When the battery is fully charged, the charging
light lights up green continuously.
Note: After approx. 30 minutes, the charging light goes
out to save energy.
Charging with the adapter
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
, The charging light shows the charging status of
the shaver (see section ‘Charge indications’ in
this chapter).
Charging in the charging stand
1 Put the small plug in the charging stand.
2 Put the adapter in the wall socket.
3 Place the shaver in the charging stand.
ENGLISH 9
Using the shaver
Note: The shaver cannot be used directly from the
mains. This shaver can be used in the bath or shower.
It can therefore not be used directly from the mains for
safety reasons.
Shaving tips and tricks
- This shaver is suitable for both wet and dry use.
Use the shaver with shaving gel or foam for extra
skin comfort, or use the shaver dry for extra
convenience.
Note: We advise you to use the shaver with shaving gel
or foam when you use it for a wet shave. Do not use
thick shaving cream or shaving oil with this shaver.
- For optimal shaving results, make circular
movements during use.
- The shaver is waterproof and can be used in
the bath or shower.
- Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
Wet shaving
1 Apply some water to your skin.
2 Apply shaving foam or shaving gel to your skin.
3 Rinse the shaving unit under the tap to ensure
that the shaving unit glides smoothly over
your skin.
ENGLISH10
4 Press the on/off button once to switch on the
shaver.
5 Move the shaving heads in circular movements
over your skin.
Note: Rinse the shaver under the tap regularly to
ensure that it continues to glide smoothly over your
skin.
6 After shaving, press the on/off button once to
switch off the shaver and dry your face.
7 Clean the shaver (see chapter ‘Cleaning and
maintenance’).
Note: Make sure you rinse all foam or shaving gel off
the shaver.
Dry shaving
1 Press the on/off button once to switch on
the shaver.
2 Move the shaving heads in circular movements
over your skin.
3 After shaving, press the on/off button once to
switch off the shaver.
4 Clean the shaver (see chapter ‘Cleaning and
maintenance’).
Trimming
You can use the trimmer to groom your sideburns
and moustache.
1 Push the trimmer slide downwards to open
the trimmer.
ENGLISH 11
2 Press the on/off button once to switch on
the shaver.
, You can now start trimming.
3 After trimming, press the on/off button once to
switch off the shaver.
4 Clean the trimmer (see chapter ‘Cleaning and
maintenance’).
5 Close the trimmer (‘click’).
Cleaning and maintenance
Remove the detachable cord from the handheld
part before cleaning this part in water.
Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids such
as petrol or acetone to clean the appliance.
- Clean the shaver after every shave for optimal
shaving performance.
- Regular cleaning guarantees better shaving
performance.
- For the best cleaning results, we advise you to use
the Philips Cleaning spray (HQ110).
- Be careful with hot water. Always check if the
water is not too hot, to prevent your hands from
getting burnt.
Note: Water may leak from the socket at the bottom
of the shaver when you rinse it. This is normal and not
dangerous because all electronics are enclosed in a
sealed power unit inside the shaver.
ENGLISH12
Cleaning the shaving unit under the tap
1 Switch off the shaver and disconnect it from
the mains.
2 Press the release button to open the shaving unit.
3 Rinse the shaving unit and hair chamber under
a hot tap for 30 seconds.
Be careful with hot water. Always check if the
water is not too hot, to prevent your hands from
getting burnt.
- Rinse the hair chamber and the inside of the
shaving unit.
- Rinse the outside of the shaving unit.
4 Close the shaving unit and shake off excess
water.
Be careful not to hit the shaving unit against
anything while shaking off excess water.
Never dry the shaving unit and the hair chamber
with a towel or tissue, as this may damage the
shaving unit.
5 Open the shaving unit again and leave it open
to let the shaver dry completely.
Cleaning the shaving unit with the cleaning
brush
1 Switch off the shaver and disconnect it from
the mains.
2 Press the release button to open the shaving unit.
ENGLISH 13
3 Pull the shaving unit off the shaver.
4 Turn the lock anticlockwise (A) and remove
the retaining frame (B).
5 Remove and clean one shaving head at a time.
Each shaving head consists of a cutter and a guard.
Note: Do not clean more than one cutter and guard at a
time, since they are all matching sets. If you accidentally
mix up the cutters and guards, it may take several weeks
before optimal shaving performance is restored.
- Remove the cutter from the shaving guard and
clean it with the brush.
- Clean the inside and outside of the shaving guard
with the brush.
6 Put the shaving heads back into the shaving
unit.
Make sure that the projections of the shaving
heads t exactly into the recesses.
ENGLISH14
7 Put the retaining frame back into the shaving
unit (A) and turn the lock clockwise (B).
8 Insert the lug of the shaving unit into the slot in
the top of the shaver . Then close the shaving unit.
Note: If the shaving unit does not close smoothly,
check if you have inserted the shaving heads properly
and if the retaining frame is locked.
Cleaning the trimmer with the cleaning brush
(AT890 only)
Clean the trimmer every time you have used it.
1 Switch off the shaver and disconnect it from
the mains.
2 Push the trimmer slide downwards to open
the trimmer.
3 Clean the trimmer with the short-bristled side
of the cleaning brush. Brush up and down along
the trimmer teeth.
4 Close the trimmer (‘ click’).
Tip: For optimal trimming performance, lubricate the
trimmer teeth with a drop of sewing machine oil every
six months.
ENGLISH 15
Storage
- Put the protection cap on the shaver to prevent
damage.
Replacement
For maximum shaving performance, we advise you
to replace the shaving heads every two years.
Replacement reminder
The shaving head symbol will light up to indicate that
the shaving heads need to be replaced.
Replace damaged shaving heads right away.
Only replace the shaving heads with original HQ8
Philips Shaving Heads.
1 The shaving head symbol lights up orange
continuously.
2 Switch off the shaver. Disconnect the shaver
from the mains, remove it from the Jet Clean
System or remove it from the charging stand.
3 Press the release button to open the shaving unit.
4 Pull the shaving unit off the shaver.
ENGLISH16
5 Turn the lock anticlockwise (A) and remove
the retaining frame (B).
6 Remove the shaving heads and place new ones
in the shaving unit.
Note: Make sure that the projections of the shaving
heads t exactly into the recesses.
7 Put the retaining frame back into the shaving
unit (A)and turn the lock clockwise (B).
8 Insert the lug of the new shaving unit into the
slot in the top of the shaver. Then close the
shaving unit.
Note: If the shaving unit does not close smoothly, check
if you have inserted the shaving heads properly and if
the retaining frame is locked.
9 Press and hold the on/off button for 5 seconds
to reset the replacement reminder on the
shaver. The orange light goes out.
ENGLISH 17
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Centre in your country (see the
worldwide guarantee leaet for contact details).
To retain the top performance of your shaver,
make sure you clean it regularly and replace its
shaving heads at the recommended time.
Shaving heads
- We advise you to replace your shaving heads
every two years. Always replace them with HQ8
Philips Shaving Heads.
Cleaning
- Use Cleaning spray (HQ110) to clean the shaving
heads thoroughly.
Recycling
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an ofcial collection point for recycling. By doing
this, you help to preserve the environment.
Removing the rechargeable shaver battery
Only remove the rechargeable battery when you
discard the shaver. Make sure the rechargeable
battery is completely empty when you remove it.
1 Disconnect the shaver from the mains.
2 Let the shaver operate until it stops.
3 Undo the screws in the back of the shaver and
in the hair chamber.
4 Remove the front panel and the back panel.
ENGLISH18
5 Bend the 6 hooks aside and take out the
power unit.
Be careful, the hooks are sharp.
6 Remove the battery.
Be careful, the battery strips are sharp.
Do not connect the shaver to the mains again after
you have removed the rechargeable battery.
Guarantee and support
If you need information or support, please visit
www.philips.com/support or read the separate
worldwide guarantee leaet.
Troubleshooting
This chapter summarises the most common
problems you could encounter with the appliance.
If you are unable to solve the problem with the
information below, visit www.philips.com/
support for a list of frequently asked questions or
contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The shaver does
not shave as well
as it used to.
The shaving
heads are
damaged or
worn.
Replace the shaving heads
(see chapter ‘Replacement’).
Foam or gel
residues clog
up the shaving
heads.
Rinse the shaving unit under a
hot tap (see chapter ‘Cleaning
and maintenance’).
ENGLISH 19
Problem Possible cause Solution
Long hairs
obstruct the
shaving heads.
Clean the shaving heads one
by one (see chapter ‘Cleaning
and maintenance’).
You have not
inserted the
shaving heads
properly.
Make sure that the projections
of the shaving heads t exactly
into the recesses (see chapter
‘Cleaning and maintenance’).
The shaver does
not work when I
press the on/off
button.
The rechargeable
battery is empty.
Recharge the battery (see
chapter ‘Charging’).
The temperature
of the shaver is
too high. In this
case, the shaver
does not work.
As soon as the temperature
of the shaver has dropped
sufciently, you can switch on
the shaver again.
The shaver does
not work, although
it is connected to
the mains.
If the shaver
does not work
when you press
the on/off button,
the battery is
empty.
This shaver is not designed
to be used directly from the
mains, so you should recharge
the battery (see chapter
‘Charging’).
ENGLISH20
1 / 1

Philips AT800/16 ユーザーマニュアル

カテゴリー
メンズシェーバー
タイプ
ユーザーマニュアル

他の言語で