ENGLISH

Introduction

Congratulations on your purchase and

welcome to Philips! To fully benet from

the support that Philips offers, register your

product at www.philips.com/welcome.

General description (Fig. 1)

1 Protection cap

2 Shaving heads

9 Charging light

10 Socket for small plug

11 Cleaning brush

12 Philips Cleaning Spray (Optional)

13 Small plug

14 Mains cord with plug

15 Cutter

16 Guard

Important

Read this user manual carefully before you

under a running tap (Fig. 2).

Warning

- This appliance is not intended for use

by persons (including children) with

reduced physical, sensory or mental

capabilities, or lack of experience and

knowledge, unless they have been given

supervision or instruction concerning

use of the appliance by a person

responsible for their safety.

have it replaced with one of the original

type in order to avoid a hazard.

Caution

- Use, charge and store the appliance at

a temperature between 5°C and 35°C.

- Only use the mains cord supplied to

charge the appliance.

- Only use the cleaning brush supplied.

- Make sure the cleaning brush remains

clean.

evidence available today.

Charging

Make sure the shaver is switched off when

you start to charge it.

When you charge the shaver for the rst

time or after a long period of disuse, let it

charge continuously for 12 hours. Charging

normally takes approx. 8 hours. Charge the

appliance when the motor stops or starts

running slower.

3 Remove the plug from the wall

socket and pull the small plug out of

the shaver when the battery is fully

charged (Fig. 5).

Note: The shaver does not run from the mains.

When the battery is empty, you have to

recharge the battery before you can use the

shaver again.

Note: The light of the shaver does not change

color and does not go out when the shaver is

the mains.

1 Remove the protection cap.

PQ217

Register your product and get support at

www.philips.com/welcome

4222.002.5451.1

2 Push the on/off slide upwards to

switch on the shaver (Fig. 6).

3 Move the shaving heads over your

Note: Shave on a dry face only. Do not use the

shaver in combination with gel, foam or water.

shave (see chapter ‘Cleaning and

to prevent damage and to avoid

dirt accumulation in the shaving

heads (Fig. 8).

Cleaning and maintenance

Never use scouring pads, abrasive cleaning

agents or aggressive liquids such as petrol

or acetone to clean the appliance.

Clean the shaver after every shave to

guarantee better shaving performance. For

use Philips Cleaning Spray. Ask your Philips

the cleaning brush supplied (Fig. 9).

3 Pull the shaving unit straight up off the

shaver (Fig. 10).

4 Clean the inside of the shaving unit

cleaning brush (Fig. 12).

shaver (Fig. 13).

Every two months: shaving heads

Note: Do not use cleaning agents or alcohol

to clean the shaving heads. Only use Philips

Cleaning Spray.

1 Switch off the shaver, remove the

plug from the wall socket and pull the

small plug out of the shaver.

3 To remove the retaining frame, turn

the central spring clockwise (1).Then

lift the retaining frame out of the

shaving unit (2) (Fig. 15).

guard (Fig. 16).

Note: Do not clean more than one cutter and

sets. If you accidentally mix up the cutters

and guards, it may take several weeks before

optimal shaving performance is restored.

5 Remove the guard from the

cutter (Fig. 17).

6 Clean the cutter with the short-

bristled side of the cleaning brush.

side of the cleaning brush (Fig. 19).

9 Put the shaving heads back into the

shaving unit (Fig. 21).

spring anti clockwise (2) (Fig. 22).

11 Put the shaving unit back onto the

Keep the appliance dry.

1 Switch off the shaver.

after use to prevent damage and to

Replace damaged or worn shaving heads

with Philips shaving heads only (HQ4 for

China or HQ56 for the rest of the world).

For instructions on how to remove the

shaving heads’.

Cleaning

- Use Philips Cleaning Spray to clean the

the environment. Always remove the

battery before you discard and hand

in the shaver at an ofcial collection

point. Dispose of the battery at an

ofcial collection point for batteries. If

you have trouble removing the battery,

you can also take the shaver to a Philips

service centre. The staff of this centre

will remove the battery for you and will

and pull the small plug out of the

2 Let the shaver run until it stops, undo

the screw on the back of the shaver

(1) and lift the back panel off the

shaver (2) (Fig. 26).

Do not connect the shaver to the mains

again after you have removed the battery.

Guarantee restrictions

guarantee because they are subject to wear.

This chapter summarises the most common

problems you could encounter with the

appliance. If you are unable to solve the

problem with the information below, contact

the Consumer Care Centre in your country.

speed of

the shav-

ing heads

is lower

makes a

strange

noise.

並避免污垢累積在刀頭中。(圖8)

絕對不可使用鋼絲絨、磨蝕性的清潔劑

或侵蝕性的液體(例如汽油或丙酮)清潔

本產品。

(圖9)

(圖10)

部。(圖11)

(圖12)

頭，並將小插頭拔離電鬍刀。

中拿出固定架(2)。(圖15)

一次取下並清洗一個刀頭。每個電

具。請依箭頭方向小心刷動。

24小時。

行充電。(圖4)

拔出，並將小插頭從電鬍刀上拔下。

(圖5)

注意：電鬍刀無法插電運轉。電池耗盡

用電鬍刀。

鬍刀電源。(圖6)

時用直線及畫圓的方式來移動。

(圖7)

鬍刀電源。

轉開電鬍刀背面的螺絲(1)，然後打

開電鬍刀的背面模板(2)。(圖26)

卸除電池後，請勿再次將電鬍刀連接

至電源。

 7  請使用清潔刷的長毛側來清潔刀網。

(圖19)

 8 清潔後，將刀具放回刀網中。

 9 將電鬍刀刀頭裝回電鬍刀組。

(圖21)

損壞，並避免污垢累積在刀頭中。

(圖8)