English | 简体中文
Yealink Camera-Hub Full HD Video Conferencing System
Yealink Network Technology CO., LTD
Quick Start Guide(V1.0)
We recommend that you use the accessories provided or approved by Yealink. The use of unapproved third-party
accessories may result in poor performance.
1
Cable Tie×5
Camera-Hub
Quick Start Guide
Power Adapter
7.5m
Ethernet Cable
Camera-Hub
Package Contents
3m RCA to
3.5mm Audio Cable
UBS3.0 to Ethernet
Adapter
2
2
Hardware Interface Instructions
1
3
2
4
3
5
6
7
8
LED Indicator: indicate different status of the
camera-hub.
Reset: Reset the camera-hub to factory defaults.
USB Port
Camera Port
RCA In: connect to an audio input device
via a RCA cable.
RCA Out: connect to the Soundbar via a RCA
cable.
VC Hub/Camera: connect to the VCM34.
3 3 4 5 6 7 8 9 10
Internet: connect to the switch to connect UVC80s.
Security slot: connect a universal security cable to the
camera-hub so that you can lock the camera-hub down.
DC48V: connect to the power adapter.
9
10
1
3
Do not connect the switch to the Internet,
otherwise it will cause network abnormalities.
The system should be used with Yealink
original power adapter (48V/0.7A) only. The
use of the third-party power adapter may
damage the system. The cable should be
replaced at once if its skin is broken.
The switch and Ethernet cables should be
purchased separately.
Connections
...
Microphone
UVC80
UVC80
Switch
Power Adapter
Mspeaker(Optional)
VCM34(Optional)
HDMI HDMI
Mini-PC
Ethernet Cable
CAT5e
3m RCA to
3.5mm Audio Cable
UBS3.0 to Ethernet
Adapter
Camera-Hub
CAT5e
CAT5e
CAT5e
CAT5e
CAT5e
CAT5e
VCM34(Optional)
VCM34(Optional) VCM34(Optional)
3
Cable Ties Installation
Flashing orange The Camera-Hub is upgrading firmware.
LED indicators on the Camera-Hub:
LED Status
Solid orange
Solid green
Solid red The Camera-Hub is in sleep mode.
Description
The Camera-Hub is initializing or upgrading the UVC80s.
The Camera-Hub is active.
LED Indicator Instructions
4
我们推荐使用由Yealink提供或经Yealink认可的配件和线缆，使用未经认可的第三方配件和线缆可能会导致性能的下降。
包装清单
电源适配器
Camera-Hub主机
7.5米网线
束线带 x5
快速入门指南
UBS3.0转RJ45
转换头
3米 RCA转
3.5mm音频线
5
硬件接口介绍
1
3
2
4
3
5
6
7
8
指示灯: 指示camera-hub的不同状态。
USB接口
Camera接口
RCA In: 使用RCA音频线连接音频输入设备。
RCA Out: 使用RCA音频线连接Soundbar。
VC Hub/Camera: 连接VCM34。
Internet接口: 连接交换机以连接UVC80摄像机。
9
10
重置键：重置设备到出厂设置。
安全锁孔 : 将主机锁在固定位置。
电源接口: 连接电源适配器
3
3
2
3 4 5 6 7 8 9 10
3
1
3
6
电源适配器
交换机
连接终端
我们要求使用Yealink原装电源（48V/0.7A），
使用第三方电源可能会导致终端损坏。如果
使用过程中发现线缆破皮，请立即更换。
交换机和相关网线需要另外购买。
...
Microphone
UVC80
UVC80
VCM34(可选)
HDMI HDMI
Mini-PC
Mspeaker(可选)
网线
CAT5e
CAT5e
CAT5e
3米 RCA转
3.5mm音频线
UBS3.0转RJ45
转换头
Camera-Hub主机
请勿将交换机接入Internet，否则会引起网络
异常。
CAT5e CAT5e CAT5e
CAT5e
VCM34(可选)
VCM34(可选) VCM34(可选)
7
使用束线带
Camera-Hub固件更新中。
Camera-Hub指示灯介绍如下:
指示灯状态
橙色灯常亮
绿灯常亮
红灯常亮 Camera-Hub处于休眠状态。
说明
Camera-Hub处于启动/等待中状态，或处于升级UVC80状态。
Camera-Hub处于正常工作状态。
指示灯介绍
橙色灯闪烁
8
Regulatory Notices
Operating Ambient Temperatures
Operating temperature: +32 to 104°F (0 to 40°C)
Relative humidity: 5% to 90%, noncondensing
Storage temperature: -22 to +160°F (-30 to +70°C)
Warranty
Our product warranty is limited only to the unit itself, when used normally
in accordance with the operating instructions and the system environment.
We are not liable for damage or loss resulting from the use of this product,
or for any claim from a third party. We are not liable for problems with
Yealink device arising from the use of this product; we are not liable for
financial damages, lost profits, claims from third parties, etc., arising from
the use of this product.
Explanation of the symbols
DC symbol
is the DC voltage symbol.
WEEE Warning symbol
To avoid the potential effects on the environment and human health
as a result of the presence of hazardous substances in electrical and
electronic equipment, end users of electrical and electronic
equipment should understand the meaning of the crossed-out wheeled bin
symbol. Do not dispose of WEEE as unsorted municipal waste and have to
collect such WEEE separately.
Restriction of Hazardous Substances Directive (RoHS)
This device complies with the requirements of the EU RoHS Directive.
Statements of compliance can be obtained by contacting [email protected].
Safety Instructions
Save these instructions. Read these safety instructions before use!
General Requirements
Before you install and use the device, read the safety instructions
carefully and observe the situation during operation.
During the process of storage, transportation, and operation, please
always keep the device dry and clean, avoid collision and crash.
Please attempt not to dismantle the device by yourself. In case of any
discrepancy, please contact the appointed maintenance center for repair.
Please refer to the relevant laws and statutes while using the device.
Legal rights of others should be respected as well.
Environmental Requirements
Place the device at a well-ventilated place. Do not expose the device
under direct sunlight.
Keep the device dry and free of dusts.
Do not place the device on or near any inflammable or fire-vulnerable
object, such as rubber-made materials.
Keep the device away from any heat source or bare fire, such as a candle
or an electric heater.
Operating Requirements
Do not let a child operate the device without guidance.
Do not let a child play with the device or any accessory in case of
accidental swallowing.
Please use the accessories provided or authorized by the manufacturer
only.
The power supply of the device shall meet the requirements of the input
voltage of the device. Please use the provided surge protection power
socket only.
Before plugging or unplugging any cable, make sure that your hands are
completely dry.
Do not spill liquid of any kind on the product or use the equipment near
water, for example, near a bathtub, washbowl, kitchen sink, wet
basement or near a swimming pool.
During a thunderstorm, stop using the device and disconnect it from the
power supply. Unplug the power plug and the Asymmetric Digital
Subscriber Line (ADSL) twisted pair (the radio frequency cable) to avoid
lightning strike.
If the device is left unused for a rather long time, disconnect it from the
power supply and unplug the power plug.
When there is smoke emitted from the device, or some abnormal noise
or smell, disconnect the device from the power supply, and unplug the
power plug immediately.
Contact the specified maintenance center for repair.
Do not insert any object into equipment slots that is not part of the
product or auxiliary product.
Before connecting a cable, connect the grounding cable of the device
first. Do not disconnect the grounding cable until you disconnect all other
cables.
Cleaning Requirements
Before cleaning the device, disconnect it from the power supply.
Use a piece of soft, dry and anti-static cloth to clean the device.
Keep the power plug clean and dry.
Troubleshooting
The unit cannot supply power to device other than Yealink device.
There is a bad connection with the plug.
1. Clean the plug with a dry cloth.
2. Connect it to another wall outlet.
The usage environment is out of operating temperature range.
1. Use in the operating temperature range.
The cable between the unit and the Yealink device is connected incorrectly.
1. Connect the cable correctly.
You cannot connect the cable properly.
1. You may have connected a wrong Yealink device.
2. Use the correct power supply.
Some dust, etc., may be in the port.
1. Clean the port.
Contact your dealer or authorized service facility for any further questions.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) this device may not cause interference; and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device. CAN ICES-3(B)
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.NMB-3(B)
Contact Information
YEALINK NETWORK TECHNOLOGY CO.,LTD.
309, 3rd Floor, No.16, Yun Ding North Road, Huli District, Xiamen City, Fujian, P.R. C
YEALINK (EUROPE) NETWORK TECHNOLOGY B.V.
Strawinskylaan 3127, Atrium Building, 8th floor, 1077ZX Amsterdam, The Netherlands
YEALINK (USA) NETWORK TECHNOLOGY CO., LTD.
999 Peachtree Street Suite 2300, Fulton, Atlanta, GA, 30309, USA
Made in China
About Yealink
Yealink is a global leading provider of enterprise communication and collaboration solutions, offering video conferencing service to worldwide
enterprises. Focusing on research and development, Yealink also insists on innovation and creation. With the outstanding technical patents of
cloud computing, audio, video and image processing technology, Yealink has built up a panoramic collaboration solution of audio and video
conferencing by merging its cloud services with a series of endpoints products. As one of the best providers in more than 140 countries and
regions including the US, the UK and Australia, Yealink ranks No.1 in the global market share of SIP phones shipments.
Technical Support
Visit Yealink WIKI (http://support.yealink.com/) for the latest firmware, guides, FAQ, Product documents, and more. For better service, we
sincerely recommend you to use Yealink Ticketing system (https://ticket.yealink.com) to submit all your technical issues.
YEALINK(XIAMEN) NETWORK TECHNOLOGY CO.,LTD.
Web: www.yealink.com
Copyright
©2020
YEALINK(XIAMEN) NETWORK
TECHNOLOGY CO.,LTD
.All rights reserved.
Ca mer a - Hub- EN+ CN
/