2. Roland
  3. CB-MCC1

Roland CB-MCC1 取扱説明書

  • Roland CB-MCC1 プロテクティブカバーの取扱説明書について、ご質問にお答えします。この説明書では、カバーの装着方法、使用上の注意、お手入れ方法、製品仕様などが記載されています。MICRO CUBEをしっかり保護するための機能や、演奏時の利便性などについてご質問ください。
  • CB-MCC1を装着したまま演奏できますか？
    電源スイッチの操作やACアダプターの接続はどうすれば良いですか？
    お手入れ方法を教えてください。
    CB-MCC1の主な素材は何ですか？
•
•
©
2009
*5100006904- 01*
CB-MCC1_l_je.fm 1 ページ ２００９年３月２４日　火曜日　午後１時１９分
Protective Cover for MICRO CUBE
CB-MCC1 Owner’s Manual
Thank you, and congratulations on your choice of the CB-MCC1 protective cover
for MICRO CUBE.
Before using this product, carefully read the section entitled: “Important
Notes.” This section provides important information concerning the proper
operation of the product.
Add
• This product is a protective cover for the MICRO CUBE.
014
• Protect the product from strong impact (Do not drop it!).
Add
• Please note that the power switch of the MICRO CUBE doesn’t turn on when
you store and/or transport it.
354a
• Do not expose the product to direct sunlight, place it near devices that
radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to
temperature extremes. Excessive heat can deform or discolor the product.
402
• Never use benzine, thinners, alcohol or solvents of any kind, to avoid the
possibility of discoloration and/or deformation.
Add
• Do not launder or wash the entire cover.
401a
• For everyday cleaning wipe the product with a soft, dry cloth or one that has
been slightly dampened with water. To remove stubborn dirt, use a cloth
impregnated with a mild, non-abrasive detergent. Afterwards, be sure to
wipe the product thoroughly with a soft, dry cloth.
926a
• Weight : 230 g
• Material : PVC (non-phthalate plasticizer used)
* In the interest of product improvement, the specifications and/or appearance of this product are
subject to change without prior notice.
202
Copyright
©
2009 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written
permission of ROLAND CORPORATION.
Important Notes
Specifications
Detach the strap from the MICRO
CUBE.
Place the cover onto the MICRO
CUBE from above.
Place the cover so that the MICRO
CUBE’s strap pins extend through
the holes in the sides of the cover.
Attach the strap.
In this condition, you can perform while
leaving the cover in place.
To operate the power switch or connect the
AC adaptor, spread the opening located on
the rear of the cover.
When transporting the MICRO
CUBE, do not grasp the belt of the
cover.
Close the fastener.
Transport or store the MICRO CUBE in this
state.
Attaching the CB-MCC1
Strap
Cover
Belt of the cover
WARNING
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
For C.A. US
(
Proposition 65
)
CB-MCC1_l_je.fm 2 ページ ２００９年３月２４日　火曜日　午後１時１９分
/