CHOETECH KH5S ユーザーマニュアル

  • こんにちは!このBluetoothセルフスティックの使用説明書の内容を読みました。このデバイスに関するご質問にお答えしますので、お気軽にご質問ください。この説明書には、使用方法、バッテリー交換方法、トラブルシューティングの情報が含まれています。
  • Bluetoothリモコンが接続できない場合はどうすればよいですか?
    Androidスマホでリモコンを使って写真が撮れない場合はどうすればよいですか?
    バッテリーを交換するにはどうすればよいですか?
蓝牙自拍杆
使用手册
手机夹 锁紧装置
伸缩杆 蓝牙遥控器
指示灯 拍照键
三脚架 补光灯(选配)
电池更换步骤
自拍杆功能介绍
可装卸式蓝牙遥控器
内置隐藏式三脚架
伸缩杆可以自由拉伸
手机夹可以360°旋转
补光灯(选配)
1.电源键:打开/关闭灯光;切换灯光模式。
2. 使用Micro-USB数据线进行充电。
温馨提示:补光灯仅为部分产品配置,请
以所购商品款式为准。
充电口
电源键
取出 安装
蓝牙遥控器的装卸
第1步:在手机上,依次点击 设置 > 蓝牙,
并将手机蓝牙打开。
第2步:长按拍照键(约2秒)直至指示灯闪
烁后成功开机。
第3步:当搜索到名为“Selfie”的蓝牙设备时
,点击并选择配对。
第4步:打开相机APP,按下拍照键即可拍摄
照片或视频。
第5步:长按拍照键(约3秒)直至指示灯熄
灭后成功关机。
温馨提示:此蓝牙遥控器兼容 Android 4.3,
IOS 5.0及以上系统版本。
蓝牙遥控使用步骤
温馨提示:本产品蓝牙遥控器含有两种
型号,请依据所购商品的样式选择对应的
步骤更换电池。
借助工具(塑料薄片,指甲等)从遥控器侧
面的凹槽处将上壳取下,取出电池进行更换
,随后将上壳对准位置后扣上即可。
1.合盖式
2.滑盖式
按照图示箭头方向将后盖推开,取出电池进
行更换,随后将后盖安装回去即可。
1.蓝牙遥控器无法开机.
·更换一块新电池。
2.开机后蓝牙无法连接/无法正常工作.
·移除手机上的蓝牙配对,重启蓝牙遥控器
后重新配对连接。
3.安卓手机如果无法使用遥控器拍照.
.按下拍照键可以调节音量.
·打开相机 App,将“音量键功能”修改成默
认或者拍照,即可使用遥控器拍照。
.按下拍照键无法调节音量.
·按照问题2的步骤重新进行配对连接。
故障排除:
NO.07
1.请勿将产品置于低温、潮湿环境保存。
2.请勿将产品置于曝晒、火烤等高温环境。
3.请勿在设备被限制的场所中使用,避免违
反公共秩序。
4.更换电池时,请将电池正极朝外放置,禁
止将正负极反接。
5.本产品含有电池,请放置于婴幼儿触摸不
到的地方,防止小孩误吞。
注意事项:
合格证
Phone Clip Fixing Knob
Telescopic Shaft Remote Control
Indicator Light Shutter Button
Built-in Tripod Fill Light (options)
Detachable Remote
Replace the Battery
Selfie Stick Introductions
The Bluetooth remote
control is detachable.
The grip can be unfolded
into a stable tripod.
The telescopic shaft can
be stretched freely.
The Phone Clip can be
rotated 360 degree.
Fill Light (options)
1.Power Button: Turn on/off the light;
Change the lighting mode.
2.Charging with Micro-USB Cable.
Reminder: The fill light is assembled for
some models. Please refer to the model of
the purchased product.
Charging Port
Power Button
Take out Mount
Quick Steps for Remote
Step 1: On your phone, tap Settings > Bluetooth,
and then turn on the Bluetooth.
Step 2: Hold down the shutter button (about 2s)
until indicator light starts flashing to turn on the
remote control.
Step 3: Once the Bluetooth name of
“Selfie”
appears in the display, select it and tap “pair”.
Step 4: Press the Shutter button to take photos.
Step 5: Hold down the shutter button (about 3s)
until indicator light goes out to turn off the
remote control.
Reminder: The remote control is compatible
with Android 4.3, IOS 5.0 and later.
Reminder: The Bluetooth remote control
has two types. Please follow the corresponding
steps to replace the battery according to the
type of your purchased product.
Force apart the upper shell at the groove on the
side of the remote with fingernail, then replace
the battery, and finally fasten the shell back.
1. Covering Type
2. Sliding Type
Slide the back cover in the direction of the arrow
as shown, then replace a new battery, and
finally insert the cover back.
1. If your phone is unable to connect to
the remote.
·Delete the Bluetooth pairing on your
phone, reboot the remote and start a
new device search.
2. If your Android phone can't take
photos when you press the shutter
button,.
·Open the camera App and change the
“Volume button function” to “Default” or
“Shutter”.
FCC Warning Statement
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment. This
equipment has been tested and found to
comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
Troubleshooting:
Attention:
1. Don’t store the product in icy or damp
environment.
2. Don’t place the product in the heat.
3. When replacing the battery, place the
positive pole “+” of the battery outwards.
4. This product contains a battery, please
place it out of the touch of infants to
prevent children from swallowing it by
mistake.
5. Don’t use the product in restricted
district to avoid violating public order.
following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired
operation.
Thanks for your support !
/