Precautions
•Do not continuously use the speaker
system beyond the peak power handling
capacity.
• Keep recorded tapes, watches, and
personal credit cards using magnetic
coding away from the speaker system to
protect them from damage caused by the
magnets in the speakers.
If you cannot find an appropriate mounting
location, consult your car dealer or your
nearest Sony dealer before mounting.
Installation/Connections
2007 Sony Corporation Printed in China
XS-GTF1325B
3-213-804-21 (1)
Unit: mm
Dimensions
13cm Coaxial
2-way Speaker
ø 130
27
ø 136
ø 163
6
ø 115
ø 75
6.3
5.0
45
5.0
4.3
12
Specifications
Speaker Coaxial 2-way:
Woofer 13 cm, HOP, cone
type
Tweeter 3.5 cm, B.D. type
Peak power 150 W*
1
Rated power 35 W*
1
Impedance 4 Ω*
1
Sensitivity 89
±
2 dB (1 W, 1 m)*
2
Frequency response 40 Hz – 25,000 Hz*
1
Mass Approx. 500 g per speaker
Supplied accessory Parts for installation
Design and specifications are subject to change
without notice.
*
1
Testing Condition : IEC60268-5 (2003-05)
*
2
Testing Condition : EIAJ RC-8124A
× aa a a a
× aa a a a
a
×
a
×
•
•
*
*
Ω*
±
*
*
1
*
2
Parts list/
Mounting/
Mounting from the car interior/
Before Mounting
A depth of at least 45 mm is required for flush
mounting. Measure the depth of the area where
you are to mount the speaker, and ensure that
the speaker is not obstructing any other
components of the car. Keep the following in
mind when choosing a mounting location:
•Make sure that nothing is obstructing around
the mounting location of the door (front or
rear) where you are to mount the speaker.
•A hole for mounting may already be cut out of
the inner panel of the door (front or rear). In
this case, you need to modify the board only.
•If you are to mount this speaker system in the
door (front or rear), make sure that the speaker
terminals, frame or magnet do not interfere
with any inner parts, such as the window
mechanism in the door (when you open or
close the window), etc.
Also make sure that the speaker grille does not
touch any inner fittings, such as the window
cranks, door handles, arm rests, door pockets,
lamps or seats etc.
•
•
•
Flat mounting/
1
6
5
3
4
2
1
× 2
5
× 2
4
× 8
3
ø 4 × 30
× 8
2
× 2
This speaker can be made to fit in almost any type of car by removing the mounting tabs.
Use clippers or pliers, etc. to cut or snap two of the mounting tabs off so that it is even with the edge of the
speaker frame as illustrated.
Note
After removing the mounting tabs, handle the speaker frame with care, as the edges may be sharp.
Mark the 4 bolt holes and make them 3.3 mm* in diameter.
*
* When using 4 : ø 5 mm
* 4 ø
c
1
ø 3.3 mm*
ø 117 mm
Door panel
Remove the grille net.
6
5
Striped cord
* White cord — Left speaker
Grey cord — Right speaker
* —
—
2
*
To speaker cord of a car.
4
3
5
2
2 mm
13 mm
Press and insert the edges of the grille net.
6
5
56
How to remove the grille net.
-
1
-
2
