Silverpark AWZY-CT138WH 取扱説明書

ブランド: Silverpark

モデル: AWZY-CT138WH

タイプ: 取扱説明書

このマニュアルも適しています

ASSEMBLY

INSTRUCTIONS

• Keep children and animals away from the desk during use.

Ensure the desktop is not touching any walls.

• Remove obstacles taller than 20"/51 cm from underneath the desk.

• Operate only in a working environment temperature of

32°F-104°F/0°C-40°C.

• Keep product away from corrosive gases, liquids and dusty objects.

• Keep hands, feet and other body parts in a safe position during

operation. Anti-collision is not automatically enabled during all resets.

• Please read the following instructions carefully before using the

height-adjustable desk.

• The company does not bear any warranty or liability for damage

and human injury caused by any abnormal or un-intended

operation of the equipment.

• It is necessary to perform a manual reset after the initial

installation or power cycling the equipment.

Caution

• Mantenga a los niños y animales alejados del escritorio durante

su uso. Asegúrese de que el escritorio no toca ninguna pared.

• Retire aquellos obstáculos con una altura superior a 20"/51 cm

de debajo del escritorio.

• Opérelo únicamente en una temperatura del entorno de

trabajo de 32°F-104°F/0°C-40°C.

• Mantenga el producto alejado de gases corrosivos, líquidos y

objetos con polvo.

• Mantenga las manos, pies y otras partes del cuerpo en una

posición segura durante el funcionamiento. No se habilita la

anticolisión de forma automática tras los reinicios.

• La empresa no ofrece ninguna garantía no asume ninguna

responsabilidad por cualquier daño o lesión humana provocada

por un funcionamiento anormal o no previsto del equipo.

• Es necesario realizar un reinicio manual tras la instalación

inicial o el ciclo de encendido.

Precaución

• Tenere i bambini e gli animali lontani dalla scrivania durante

l'uso. Assicurarsi che il piano non tocchi alcuna parete.

• Rimuovere gli ostacoli più alti di 20"/51 cm da sotto la scrivania.

• Operare solo in un ambiente di lavoro con una temperatura di

32°F-104°F/0°C-40°C.

• Tenere il prodotto lontano da gas e liquidi corrosivi e oggetti

polverosi.

• Tenere mani, piedi e altre parti del corpo in posizione di

sicurezza durante il funzionamento. L'anti-collisione non è

automaticamente attivata dopo il ripristino.

• La società non si assume alcuna garanzia o responsabilità per

danni e lesioni umane causati da un funzionamento anomalo o

non previsto dell'apparecchiatura.

• È necessario eseguire un ripristino manuale dopo l'installazione

iniziale o il ciclo di alimentazione.

Attenzione

• Halten Sie Kinder und Tiere während der Benutzung vom Tisch

fern. Achten Sie darauf, dass die Tischplatte keine Wände berührt.

• Entfernen Sie Hindernisse, die höher als 20"/51 cm Zoll sind,

von der Unterseite des Tisches.

• Betreiben Sie das Gerät nur in einer Arbeitsumgebung mit einer

Temperatur von 32°F-104°F/0°C-40°C.

• Halten Sie das Produkt von ätzenden Gasen, Flüssigkeiten und

staubigen Gegenständen fern.

• Halten Sie Hände, Füße und andere Körperteile während des

Betriebs in einer sicheren Position. Der Antikollisionsschutz wird

nach den Zurücksetzen nicht automatisch aktiviert.

• Das Unternehmen übernimmt keine Garantie oder Haftung für

Schäden und Verletzungen, die durch einen abnormalen oder

unbeabsichtigten Betrieb des Geräts verursacht werden.

• Nach der Erstinstallation oder dem Ersteinschalten der

Stromversorgung muss eine manuelle Rückstellung vorgenommen

werden.

Vorsicht

• Pendant l'utilisation, gardez les enfants et les animaux à l'écart

du bureau. Veillez à ce que le bureau ne touche aucun mur.

• Éliminez les obstacles de plus de 20"/51 cm pouces de hauteur

sous le bureau.

• N'utilisez le produit que dans un environnement de travail dont

la température est comprise entre 32°F-104°F/0°C-40°C.

• Éloignez le produit de toute source de gaz corrosifs, de liquides

et d'objets poussiéreux.

• Gardez les mains, les pieds et les autres parties du corps dans

une position sûre lorsque vous utilisez l'appareil. L'anticollision

n'est pas automatiquement activée après les réinitialisations.

• Aucune garantie ou responsabilité n'est assumée par la société

pour les dommages et les blessures humaines causés par un

fonctionnement anormal ou non intentionnel de l'équipement.

• Une réinitialisation manuelle est indispensable après l'installation

initiale ou un cycle d'alimentation.

Attention

English

Español

Italiano

Deutsch

Français

•

• 20

• 32°F−104°F0°C−40°C

•

2V4

x10

x5(40”/48”)

x6(55”/63”)

x3(40”/48”/55”)

x4(63”)

M6x25

M6x16

M6x14

ST5x14

x26(40”/48”/55”)

x28(63”)

M6x25

M6x16

40”/48”

ST5x14

55”

ST5x14

63”

ST5x14

90°

60°

ST5x14

M6x14

13 K

English 18

Italiano 30

Deutsch

Español

Français

1 2 3 M

Note

English

Desktop height

Press and hold for 5 sec

Press and hold for 2 sec

Up Down Preset heights Setting Lock

Please make sure that there are no obstacles during the lifting

process of the table, the table is not close to the wall, and the

length of the wire is enough for the table to move up and down.

Recommendation

Reset of fault protection

Phenomenon

Preset the most comfortable height when you sit down as 1,

the most comfortable height when you stand up as 2, and the

remaining preset height can be freely set to another height.

After the controller reports an error, the digital display shows

“E07-E09”. Even if it is powered on after de-energized, the error

display remains, and all keys still do not work.

Reset method

Press and hold “Down” key for 5 seconds, and the digital display

shows “RST”. Release the key and then press “Down” key to reset.

Setting of upper limit

Press “M” key, the digital display shows "S-" and release the key.

Press and hold “Up” key, the digital display ﬂashes once, and

release the key. Press “M” key again and hold it for 2 seconds,

and the digital display shows "999". The upper limit setting is

completed.

Setting of lower limit

Press “M” key, the digital display shows "S-" and release the key.

Press and hold “Down” key, the digital display ﬂashes once, and

release the key. Press “M” key again and hold it for 2 seconds,

and the digital display shows "000". The lower limit setting is

completed.

1 2 3 M

89.5

1 2 3 M

E08

1 2 3 M

999

1 2 3 M

000

Press and hold for 2 sec

Press and hold for 3 sec

Press and hold for 5 sec

Cancellation of limit

Press “M” key, the digital display shows "S-" and release the key.

Press “M” key again and hold it for 2 seconds, and the digital

display shows "555". The upper and lower limit settings are

deleted.

Locking

Press for 3 seconds, the digital display shows “LOC”, and

manual controller keys are locked.

Switching of inching with memory/continuous

movement with memory

In the reset state, that is, the digital display shows “RST”.

Press and hold "1" key for 5 seconds to switch the mode between

inching with memory and continuous movement with memory.

The digital display shows "10.1", and the continuous movement

mode starts from the memory position.

The digital display shows "10.2", and the inching mode starts from

the memory position.

Adjustment of minimum height value

In the reset state, that is, the digital display shows “RST”. Press

and hold "M" key for 5 seconds, and the digital display shows the

default value after reset, and ﬂashes on and oﬀ.

Press “Up” key or “Down” key to adjust to the required height

value. After releasing the key for 5 seconds, the digital display

shows “RST” and the adjustment is successful.

Unlocking

Press for 3 seconds, the digital display shows digits, and

manual controller keys are unlocked.

1 2 3 M

555

1 2 3 M

LOC

1 2 3 M

RST

1 2 3 M

RST

ページが読み込まれています...

Silverpark AWZY-CT138WH 取扱説明書

ブランド: Silverpark

モデル: AWZY-CT138WH

タイプ: 取扱説明書

このマニュアルも適しています

PDFをダウンロードします

報告

他の言語で

italiano: Silverpark AWZY-CT138WH Istruzioni per l'uso
español: Silverpark AWZY-CT138WH Instrucciones de operación
Deutsch: Silverpark AWZY-CT138WH Bedienungsanleitung
français: Silverpark AWZY-CT138WH Mode d'emploi