3
User’s Manual
Introduction
This manual describes how to replace the currently installed UB-BOARD with a UB-U06 board in TM
series printers designed for this board.
Standards and Approvals
Product Name: UB-U06
Model Name: M186B
The following standards are applied only to the boards that are so labeled. (EMC is tested using the EPSON AC Adapters and TM series printers.)
Europe: CE marking
North America: FCC/ICES-003 Class A
Oceania: CISPR22 Class A
WARNING
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate measures.
The connection of a non-shielded interface cable to this board will invalidate the EMC standards of this device.
You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the
equipment.
CE Marking
The printer conforms to the following Directives and Norms:
Directive 2004/108/EC EN 55022 Class A
EN 55024 IEC 61000-4-2 IEC 61000-4-3
IEC 61000-4-4 IEC 61000-4-5
IEC 61000-4-6 IEC 61000-4-11
The printers in which this board is installed do not conform to the following:
Directive 90/384/EEC EN 45501
FCC Compliance Statement
For American Users
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at his own expense.
For Canadian Users
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Precautions
• Disconnect the power supply from the printer before you remove or install a UB-U06; otherwise
you may damage the UB-U06 and the printer. You must disconnect the power supply because the
electrical current is flowing in some parts of the printer circuit even when the power switch is turned
off.
• Wear a grounded wrist strap when handling the UB-U06 to prevent damage from static electricity.
• To avoid contamination, do not touch the UB-U06 connector.
Operation Environments and Models
• Operation Environments
*1
:
Hardware: USB Plus Power compliant PC
OS: Windows 98 (Second Edition is recommended.) or later
Software: You need device driver if you use the UB-U06.
Please ask your dealer how to get the device driver for the
UB-U06 and how to install it.
*1: Even if the above operation environments are satisfied, your system may not
work properly, depending on the devices connected to your system.
• Supported printers:
There is limitation of the printers that can be used with the UB-U06. Please ask your dealer
for the printer information.
Copyright 2003 Seiko Epson Corporation
Printed in China