English
Note
•After the battery is replaced, the
setting of the SOUND and MODE
buttons will be erased.
Battery life* (Approx. hours)
(in playback)
Rechargeable NH-10WM 22
fully charged**
Sony alkaline LR6 (SG)*** 46
Rechargeable NH-10WM 68
Sony alkaline LR6 (SG)***
used together
* Measured value by the standard of
JEITA (Japan Electronics and
Information Technology Industries
Association). (Using a Sony HF
series cassette tape)
** Charging time varies depending on
how the rechageable battery is used.
*** When using a Sony LR6 (SG)
“STAMINA” alkaline dry battery
(produced in Japan).
Note
•The battery life may be shorter
depending on the operating
condition, the surrounding
temperature and battery type.
Playing a Tape
1 Insert a cassette and if the
HOLD function is on, slide
the HOLD switch in the
opposite direction of the
arrow to unlock the
controls.
2 Press Y (play)•x (stop)
on the remote control and
adjust the volume with
VOL. (On the main unit,
press Y•REPEAT.)
When adjusting the volume
on the remote control
Set the VOL control on the main unit
to around 6.
When adjusting the volume
on the main unit
Set the VOL control on the remote
control at maximum.
Operation on the remote
control
To
Switch playback
to the other side
Stop playback
Fast forward*
Rewind*
Play the other
side from the
beginning
(Skip Reverse
function)
Play the same
side from the
beginning
(Rewind Auto
Play function)
Repeat the
current track
(Repeat Single
Track
function)
Adjusting Playback Mode
You can adjust the playback
direction mode (s or d) as
well as the BL SKIP mode (on or
off).
1 Press MODE repeatedly. With
each press the indications
change as follows:
s
r
s BL SKIP
r
d
r
d BL SKIP
•When “BL SKIP” is displayed, the
tape is fast-forwarded to the next
track if there is a blank space of
longer than 12 seconds. You will
hear repeated sets of three short
beeps when skipping a blank.
•When “s” is displayed , both
sides of the tape is played
repeatedly.
•When “d” is displayed, both
sides of the tape is played once (if
you start from R (REV) side, only
R (REV) side will be played).
Note
• You cannot adjust the playback
mode during fast-forward or rewind.
Emphasizing Sound
1 Press SOUND repeatedly. With
each press, the indications
change as follows:
RV (Sound Revitalizer):
emphasizes treble sound
MB (Mega Bass): emphasizes
bass sound (moderate
effect)
GRV (Groove): emphasizes bass
sound (strong effect)
none: normal (no effect)
Notes
• If the sound becomes distorted in
the GRV mode, select a different
sound mode.
• You cannot change the mode during
fast-forward or rewind.
Protecting Your Hearing —
AVLS (Automatic Volume
Limiter System)
Hold down MODE until “AVLS”
appears in the display (about 10
seconds).
To cancel the AVLS function
Hold down MODE again until
“AVLS” disappears from the
display.
Note
• You cannot turn on/off the AVLS
function during fast-forward or
rewind.
Locking the Controls
— HOLD Function
Slide the HOLD switch in the
direction of the arrow to lock the
controls of the Walkman (except
SPEED CONTROL) or the remote
control.
Operation on the main unit
To
Switch
playback to
the other side
Stop playback
Fast forward*
Rewind*
Play the other
side from the
beginning
(Skip Reverse
function)
Play the same
side from the
beginning
(Rewind Auto
Play function)
Repeat the
current track
(Repeat Single
Track
function)
* If Y•x on the remote control is
pressed during fast forward or
rewind, the Walkman switches to
playback.
Other tape operations
To play the next track/
succeeding 9 tracks from the
beginning (AMS*)
On the remote control: Press FF
once/repeatedly during playback.
On the main unit: Press FF/
CUE•AMS once/repeatedly during
playback.
To play the current track/
previous 8 tracks from the
beginning (AMS*)
On the remote control: Press REW
once/repeatedly during playback.
On the main unit: Press REW/
REVIEW•AMS once/repeatedly
during playback.
* Automatic Music Sensor
Fast forward/rewind while
listening to the sound (CUE/
REVIEW)
On the remote control: Press and
hold FF or REW during playback
and release it at the point you want.
On the main unit: Press and hold
FF/CUE•AMS or REW/REVIEW•
AMS during playback and release it
at the point you want.
Using Other Functions
Adjusting the Tape
Playback Speed
You can adjust the playback speed
using SPEED CONTROL.
Turn SPEED CONTROL to:
SLOW (slow) to play back at a
slower speed.
Center position to play back at
normal speed.
FAST (fast) to play back at a faster
speed.
B
•
c
c
•100
•
*
NH-10WM 100% ** 22
LR6 SG *** 46
*** 68
* JEITA HF
**
*** LR6 SG
•
•
AMS 1
B
10
Preparations
Prepare a dry battery (not supplied)
or the rechargeable battery
(supplied).
Dry Battery
Attach the supplied battery case,
and then insert one R6 (size AA)
battery with correct polarity.
Note
•For maximum performance we
recommend that you use a Sony
alkaline battery.
Rechargeable Battery
Charge the rechargeable battery
before using it for the first time.
1 Insert the supplied
rechargeable battery NH-
10WM into the rechargeable
battery compartment with
correct polarity.
2 Connect the supplied AC
power adaptor to the charging
stand, plug in the AC power
adaptor to the house current
(mains).
3 Place the main unit on the
charging stand.
The CHG lamp will light up.
Full charging takes about 6
hours regardless of the battery
power remaining.
Notes
•This charging stand charges the
rechargeable battery based on a
timer. If you remove the unit from
the charging stand while it is
charging, the timer will be reset and
full charging will take about 6 hours
when you place the unit on the
charging stand again.
•You can use the unit before the
CHG lamp goes off, but in that case,
battery life will be shorter
depending on the charging time.
•Do not use the unit while it is
charging. Remove the unit from the
charging stand when using it.
– If you operate the unit while it is
charging, the battery will not be
charged.
– If you operate the unit while it is
charging, this may cause a
malfunction.
•Do not place the unit on the
charging stand without the
rechargeable battery. Otherwise, this
may cause a malfunction.
Notes on the AC power adaptor
•Use only the supplied AC power
adaptor. Do not use any other AC
power adaptor.
•Connect the AC power adaptor to
an easily accessible AC outlet.
Should you notice an abnormality in
the AC power adaptor, disconnect it
from the AC outlet immediately.
•Do not touch the AC power adaptor
with wet hands.
When to replace/charge the
battery
Replace or charge the battery when
“e” flashes in the display on the
reomte control.
•
•
•
• AC
•
http://www.baj.or.jp/
AC
• AC JEITA
AC
•AC
•
•
• 1
•
•
90
•
*3018 000 Hz
1
8 300
DC *4 mW + 4 mW 16
20% 15%
DC 1.5 V NH-10WM 1.2 V 900 mAh
(MIN) Ni-MH) 3 1
*
77.1
×
108.0
×
20.4 mm / /
* 78.0
×
108.7
×
22.5 mm / /
142 g 166 g
* JEITA
CE — EEA
—
NH-10WM * MDR-
ED238SP GROOVE MDR-Q22SL MDR-E848SP MDR-EX70SL MDR-
EX71SL
*
i
AMS
1
AMS
AVLS AVLS
SPEED CONTROL SPEED CONTROL
——— 15
40
0
CHG
Press
Y•x for more
than a second
during playback
Y•x once
during playback
FF during stop
REW during stop
FF for 2 seconds
or more during
stop
REW for 2
seconds or more
during
stop
Y•x twice
during playback
To stop a single
repeat, press
Y•x once.
B
L R
1
HOLD
2
VOL *
3 Y
•REPEAT **
4 x
5
FF/CUE•AMS / AMS
6
REW/REVIEW•AMS / AMS
7
8 i
9
SPEED CONTROL
0
OPEN
qa
qs
qd
REW – AMS
qf
FF + AMS
qg
qh Y
•
x
**
qj
SOUND
qk
MODE AVLS
ql
DC IN 4.5V
w;
wa
CHG
*
VOL
**
Press
Y•REPEAT
during playback
x
FF/CUE•AMS
once during stop
REW/REVIEW•
AMS once during
stop
FF/CUE•AMS for
2 seconds or more
during stop
REW/REVIEW•
AMS for 2 seconds
or more during
stop
Y•REPEAT for 2
seconds or more
during playback
To stop a single
repeat, press it again.
Polarity of
the plug