dji Osmo Action 4 ユーザーガイド

タイプ
ユーザーガイド

このマニュアルも適しています

Copyright © 2022 DJI All Rights Reserved 1
发布日期:
2023.11.27
固件版本:
04.02.01.13
本次更新
新增自动关机功能,发射器在未连接任何设备且未开启独立录音的情况下,15 分钟后会自动关机。
优化发射器使用稳定性。
修复部分已知问题。
升级步骤
1. 在产品页面下载升级固件。
2. 确保发射器处于开机状态,使用标配的 USB-C 线连接发射器至电脑。
3. 将下载的固件包(.bin 结尾的文件)放置到发射器的根目录下
4. 断开电脑连接,发射器将自动开始升级。升级过程中发射器的系统状态指示灯红绿交替闪烁
5. 升级完成后,可在相机端查看固件版本,确认已成功升级至最新固件。
6. 若升级失败,请重新下载升级固件重启发射器,重复上述步骤至升级成功若升级仍然失败请联系
DJI 技术支持解决
Copyright © 2022 DJI All Rights Reserved 2
Date:
2023.11.27
Firmware Version:
04.02.01.13
Whats New
Added auto power off function when the transmitter is not connected to a device and is not recording
independently for more than 15 minutes.
Optimized transmitter stability during usage.
Fixed some minor bugs.
Steps to Update
1. Download the firmware on the product page of the DJI official Website.
2. Make sure the transmitter is powered on. Connect the transmitter to a computer using the UCB-C cable
provided.
3. Place the downloaded firmware update package .bin file under the root directory of the transmitter.
4. The transmitter firmware updates will start automatically after disconnecting the transmitter from the
computer. During the transmitter updating process, the system status LED will flash red and green.
5. After the firmware update is complete, check the firmware version on a camera to ensure the firmware has
been updated successfully.
6. If the firmware update fails, download the firmware again, reboot the transmitter, and repeat the steps above.
Contact DJI Support if the update fails again.
  • Page 1 1
  • Page 2 2

dji Osmo Action 4 ユーザーガイド

タイプ
ユーザーガイド
このマニュアルも適しています

他の言語で