©
5100003190 1YZ
1.
2.
3.
4.
*5100003190- 01*
BNC-assembly_j.fm 1 ページ ２００８年７月３０日 水曜日 午前１１時０分
Copyright © 2008 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written
permission of ROLAND CORPORATION.
5100003190 1YZ
*5100003190- 01*
Piano Bench Assembly Manual
Thank you for purchasing this piano bench.
Please read this manual carefully and assemble the bench as directed, performing each step in the order
given.
Checking the Included Items
No.
Part name Q’ty
1
Bench (seat)
1
2
Legs
4
3
Nuts
4
4
Spring washers
4
5
Wrench
1
6
Leg caps
4
Assembly Diagram
1.
Place the bench seat upside down. Pass
the threaded portion of each leg bolt
through the bolt holes of the bench
seat, attach a spring washer and a nut
(in that order), and finger-tighten the
nut. Do this for each of the four legs.
* Tighten the nuts by hand when performing this
step; do not use the included wrench yet.
2.
Place the bench upright. If one or two
legs are not in contact with the floor,
pull them down so that all four legs
contact the floor evenly.
* Perform this step in the location where you'll
be using the bench.
* If the floor is significantly uneven, perform the
assembly in a location that is flat.
3.
Taking care not to touch the legs, place
the bench upside down once more, and
use the wrench to tighten the bolts until
there is no gap between the spring
washer and bolt.
4.
If desired, attach the included leg caps.
If the height of the bench is adjustable, turn the
knob to adjust the height appropriately for the
person who will be playing the piano.
Assembly Procedure
Adjusting the Height
BNC-assembly_e.fm 1 ページ ２００８年７月３０日 水曜日 午前１１時１分
-
1
-
2
