N30 RGB LED controller is designed to drive constant
voltage LED products with common anode connection in
voltage range of DC5-24V. The main unit works with a RF
remote controller, user can setup RGB LED color,
brightness and dynamic modes on the remote controller,
the main unit is powered by DC power supply and receives
remote controller commands to drive LED fixtures.
RGB LED Controller
Wireless Remote Control
Full Protection High Power
Wireless Remote Easy Operation
Compact Size Wide Voltage Range
1. Power supply input
Install positive power cable into the terminal marked
with ‘+’ and negative power cable into the terminal marked
with ‘-’. The controller can accept DC power from 5V to
24V, the output voltage is the same as the power supply, so
please make sure the LED rated voltage is same as the
power supply.
2. LED output
Connect LED fixtures to this terminal. Install LED
common anode cable into the terminal marked with ‘+’ and
each channel LED cables into the terminal marked with R,
G, B. Please make sure the LED rated voltage is same as
the power supply and each channel’s maximum load
current is below the controller rated current.
The controller will run into protection if the output
been overloaded or short circuited. The indicator will flash
red color and stop working in this case, Please check the
wiring and load current to remove the fault.
3. Work status indicator
This indicator shows all working status of the
controller. It displays different events as following:
Steady green: Normal working.
Single green blink: Command received.
Long single green blink: Mode or color cycle edge.
Long single yellow blink: Brightness or speed limit.
Red flash: Overload protection.
Yellow flash: Over heat protection.
Green flash 3 times: New remote controller paired.
7
4
5
6
4. Turn ON / OFF
Press ‘I’ key to turn on unit or press ‘O’ key to turn off.
Main unit will memorize the on/off status and will restore
to the previous status on next power on.
5. Static RGB color setting
The keys in this area set the RGB static color and
brightness.
Press the colored keys to set the RGB LEDs to
correspond color as shortcut.
For other static colors, please press and keys to
select from the preset library colors.
Press and keys to adjust color brightness.
87mm
24mm
72mm
1 2
3
Introduction
Dimension
Wiring & Indicator
11
Functions
Please use remote controller to turn on the unit if it
was switched to off status before power cut.
2 3
Model: N30
COLOR COLOR
