* 5 1 0 0 0 3 7 4 9 5 - 0 1 *
Loading/Saving HP508 Piano Setups
Loading a Piano Setup
1. Connect your USB ash drive to the piano’s USB memory
port.
2. While holding down the [Song Balance] button, press the
[AB Repeat] button.
The [Song Balance] button and [AB Repeat] button will light; the
HP508 will be in Function mode.
3. Use the [ ] [ ] (Slow/Fast) buttons to choose “Piano Setup
Import.”
4. Press the [Song] button.
The Piano Setup Import screen will appear.
If you decide to cancel without loading the piano setup, press the
[Metronome] button.
5. Use the [+] [-] buttons to select the piano setup that you
want to load.
6. Press the [Song] button.
The piano setup will be loaded from the USB ash drive.
7. Press the [ ] (Fast) button.
When the piano setup has nished loading, you’ll return to the screen
of step 4.
The loaded piano setup is automatically backed-up to memory.
If you press the [
] (Slow) button, loading will be cancelled and
you’ll return to the screen of step 6.
8. Press the [Song Balance] button or the [AB Repeat] button
to exit Function mode.
Saving a Piano Setup
1. Connect your USB ash drive to the piano’s USB memory
port.
2. While holding down the [Song Balance] button, press the
[AB Repeat] button.
The [Song Balance] button and [AB Repeat] button will light; the
HP508 will be in Function mode.
3. Use the [ ] [ ] (Slow/Fast) buttons to choose “Piano
Setup Export.”
4. Press the [Song] button.
The Piano Setup Export screen will appear.
The HP508 lets you load a piano setup that you’ve saved on a USB ash drive, or save your piano setup to a USB ash drive.
MEMO
Only piano setups that were created on the HP508 can be loaded.
HP508
If you decide to cancel without saving the piano setup, press the
[Metronome] button.
5. Use the [+] [-] buttons to specify the save-destination
number.
No piano setup has been saved in numbers whose piano setup name
is shown as (Empty).
If you want to save by overwriting an unwanted piano setup, choose
the unwanted piano setup number.
You can press the [
] (Fast) button to edit the name of the piano
setup.
Use the [ ] [ ] (Slow/Fast) buttons to select the position at
which to change the character.
Use the [+] [-] buttons to change the character.
6. Press the [Song] button to save the piano setup to your USB
ash drive.
If you decide to cancel, press the [Metronome] button.
When the piano setup has been saved, you will return to the screen
of step 3.
NOTE
Never turn o the power or disconnect the USB ash drive while
the screen indicates “Executing...”
7. Press the [Song Balance] button or the [AB Repeat] button
to exit Function mode.
Items saved in the piano setup
Piano Designer settings
Lid
Damper Resonance
Hammer Noise
Hammer Response
Duplex Scale
Dynamic Harmonic
String Resonance
Key O Resonance
Cabinet Resonance
Soundboard Behavior
Damper Noise
Master Tuning
Temperament
Temperament Key
Stretch Tuning
Note Volume
Note Character
Other
Ambience (On/O , value)
Brilliance (value)
Key Touch (On/O , value)
Headphones 3D Ambience
Volume Limit
Items automatically
remembered by the HP508
Volume (Speaker, headphones)
Copyright © 2013 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any
form without the written permission of ROLAND CORPORATION.
/