•
•
1.
2.
3.
4.
5.
6.
7.
8.
H1 [KICK]
Linea
r
0
6
K 2
12
6
2.0
OFF
40343345 ’03-6-3N
1.
2.
3.
4.
5.
•
•
•
•
13
42
56
HEAD MADE BY REMO U.S.A.
Before using the KD-120, you need to follow the steps below to make the appropriate
settings for the TD-10.
However, these settings won't be necessary if your TD-10 has been upgraded by means
of the TDW-1.
Should you neglect to make the appropriate settings for the TD-10, you could likely experience the
following problems:
• Sometimes the kick drum does not sound (uneven volume)
• The volume of kick drum is too small (reduced sensitivity)
Procedure
* Do not strike any pads or step on any pedals (except the KD-120) until the following settings are complete.
1. Press the [SETUP] button.
The “SETUP MENU” screen appears.
2. Press the [F1 (TRIG)] button.
The “TRIGGER BASIC” screen appears.
3. Use the [TRIG SELECT] buttons to select the pad being used
for the kick.
The upper right of the display will show “H1 [KICK]”.
4. Use the [CURSOR] buttons and [VALUE] dial to modify the
values of the settings so they match those in the screen
depicted at right.
5. Press the [F1 (BANK)] button.
The “TRIGGER BANK” screen appears.
6. Using the [CURSOR] buttons and [VALUE] dial, change the
setting so it matches that shown at right (K 2).
7. Press the [F3 (ADVNCD)] button.
The “TRIGGER ADVANCED” screen appears.
8. Use the [CURSOR] buttons and [VALUE] dial to modify the
values of the settings so they match those shown at right.
This completes the settings you need to make for the TD-10.
H1 [KICK]
Linear
0
6
K 2
12
6
2.0
OFF
For KD-120 and
Non-Expanded TD-10 Owners
40343345 ’03-6-3N
If you experience any of the above-mentioned problems even after you’ve made
the correct settings, try adjusting the head tension and mounting the kick pedal,
as described in the following.
Adjusting the head tension
Head tension that is too loose may cause problems. Adjust the head tension according to the following procedure.
Procedure
1. Loosen all six lock nuts.
2. Using a tuning key, loosen the tuning bolts until a slight gap is
produced.
3. Tighten all tuning bolts by hand, as tightly as you can.
4. Using the tuning key, turn the tuning bolts a half to a full revolution
each, thus tightening them.
Tighten each tuning bolt one by one, observing the numerical order shown at right.
5. Tighten all lock nuts to prevent loosening of the tuning bolts.
This completes the head tension adjustment.
Notes concerning installation of the kick pedal on the KD-120.
• Install the kick pedal securely.
• Set the KD-120 so no mechanical noise is heard when you step on pedal.
• Make sure that KD-120 does not touch the stand or the other pads.
• Moving the beater’s striking point upwards from the center of the head increases the sensitivity a little.
Tuning bolt
Slight gap
Lock nut
13
42
56
HEAD MADE BY REMO U.S.A.
/