Dell PowerVault NX3100 クイックスタートガイド

Dell™ PowerVault™

NX3100 Systems

Getting Started

With Your System

系统使用入门

Memulai Pengaktifan dengan Sistem Anda

はじめに

시스템 시작 안내서

Dell™ PowerVault™

NX3100 Systems

Getting Started

With Your System

Regulatory Model E13S Series

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use of

your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data if

instructions are not followed.

WARNING: A WARNING indicates a potential for property damage, personal

injury, or death.

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden.

Trademarks used in this text: Dell, the DELL logo, and PowerVault are trademarks of Dell Inc.;

Intel and Xeon are registered trademarks of Intel Corporation in the U.S. and other countries.

Microsoft and Windows are either trademarks or registered trademarks of Microsoft Corporation

in the United States and/or other countries.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and

trade names other than its own.

Regulatory Model E13S Series

February 2010 P/N 50KNY Rev. A00

Getting Started With Your System 3

Installation and Configuration

WARNING: Before performing the following procedure, review the safety

instructions that came with the system.

Unpacking the System

Unpack your system and identify each item.

Assemble the rails and install the system in the rack following the safety

instructions and the rack installation instructions provided with your system.

4 Getting Started With Your System

Optional – Connecting the Keyboard, Mouse, and Monitor

Connect the keyboard, mouse, and monitor (optional).

The connectors on the back of your system have icons indicating which cable

to plug into each connector. Be sure to tighten the screws (if any) on the

monitor's cable connector.

Connecting the Power Cable(s)

Connect the system’s power cable(s) to the system and, if a monitor is used,

connect the monitor’s power cable to the monitor.

Getting Started With Your System 5

Securing the Power Cable(s)

Bend the system power cable into a loop as shown in the illustration and secure

the cable to the bracket using the provided strap. Plug the other end of the

power cable into a grounded electrical outlet or a separate power source such as

an uninterrupted power supply (UPS) or a power distribution unit (PDU).

Turning On the System

Press the power button on the system and the monitor. The power indicators

should light.

6 Getting Started With Your System

Installing the Optional Bezel

Install the bezel (optional).

Supported Operating System

Your system is preinstalled with Microsoft

®

Windows

®

Storage Server 2008 (x64)

Edition.

NOTE: For the latest information on supported operating systems,

see support.dell.com.

Getting Started With Your System 7

Other Information You May Need

WARNING: See the safety and regulatory information that shipped with

your system. Warranty information may be included within this document or

as a separate document.

• The rack documentation included with your rack solution describes

how to install your system into a rack.

• The

Hardware Owner’s Manual

provides information about system

features and describes how to troubleshoot the system and install or

replace system components. This document is available online at

support.dell.com/manuals

.

• Any media that ships with your system that provides documentation

and tools for configuring and managing your system, including those

pertaining to the operating system, system management software,

system updates, and system components that you purchased

with your system.

NOTE: Always check for updates on support.dell.com/manuals and read the

updates first because they often supersede information in other documents.

Obtaining Technical Assistance

If you do not understand a procedure in this guide or if the system does

not perform as expected, see your Hardware Owner’s Manual. Dell™ offers

comprehensive hardware training and certification. See dell.com/training for

more information. This service may not be offered in all locations.

8 Getting Started With Your System

NOM Information (Mexico Only)

The following information is provided on the device described in this

document in compliance with the requirements of the official Mexican

standards (NOM):

Technical Specifications

Importer:

Model number: E13S Series

Supply voltage: 100–240 V CA

Frequency: 50/60 Hz

Current consumption: 7.5–4.0 A

Processor

Processor type Two Intel

®

Xeon

®

processors 5500

or 5600 series

Expansion Bus

Bus type PCI Express Generation 2

Expansion slots using riser cards

NOTE: Depending on the configuration, your system may have either riser 1 or riser 2.

Riser 1

OR

Riser 2

Slot 1: PCIe x4, half-length, full-height

Slot 2: PCIe x4, full-length, full-height

Slot 3: PCIe x8, half-length, full-height

Slot 4: PCIe x4, internal slot for integrated card

NOTE: All four slots are x8 connectors.

Slot 1: PCIe x16, full-length, full-height

Slot 2: PCIe x4, internal for integrated card

NOTE: A General Purpose Computation on

Graphics Processing Units (GPGPU) optimized

configuration is available on riser 2.

Getting Started With Your System 9

Memory

Architecture 1066 or 1333 MHz DDR3 registered or

unbuffered Error Correcting Code (ECC)

DIMMs

Memory module sockets Eight 240-pin

Memory module capacities 1 GB, 2 GB, 4 GB, or 8 GB

Minimum RAM 1 GB with a single processor

(one DIMM per processor)

Maximum RAM 64 GB (8 GB dual- and quad-rank DIMMs)

Drives

Hard drives Up to twelve 3.5-inch or 2.5-inch,

hot-swappable SAS, SATA, or SSD drives and

up to two cabled 2.5-inch SAS drives

Optical drive External USB DVD-ROM

Connectors

Back

NIC

Two RJ-45 (for integrated 1 GB NICs)

Serial

9-pin, DTE, 16550-compatible

USB

Two 4-pin, USB 2.0-compliant

Video

15-pin VGA

Front

Video

15-pin VGA

USB

One 4-pin, USB 2.0-compliant

Internal

USB

Two 4-pin, USB 2.0-compliant

Video

Video type Matrox G200, integrated in the BMC

Video memory 8 MB

10 Getting Started With Your System

Power

AC power supply (per power supply)

Wa tt ag e

750 W (optional redundant power supply)

Voltage

100–240 VAC, autoranging, 50–60 Hz

Heat dissipation

2450 BTU/hr maximum

Maximum inrush current

Under typical line conditions and over the

entire system ambient operating range,

the inrush current may reach 55 A per

power supply for 10 ms or less.

Batteries

System battery

CR 2032 3.0-V Lithium coin cell

Physical

Height 8.67 cm (3.42 inches)

Width 44.52 cm (17.53 inches)

Depth 66.46 cm (26.17 inches)

Weight (maximum configuration) 29.0 kg (63.8 lbs)

Weight (empty) 15.85 kg (34.87 lbs)

Environmental

NOTE: For additional information about environmental measurements for specific

system configurations, see www .dell.com/environmental_datasheets.

Temperature

Operating

10° to 35°C (50° to 95°F) with a maximum

temperature gradation of 10°C per hour

NOTE: For altitudes above 2950 ft,

the maximum operating temperature is

derated 1ºF/550 ft.

Storage

–40° to 65°C (–40° to 149°F) with a

maximum temperature gradation

of 20°C per hour

Getting Started With Your System 11

Relative humidity

Operating

20% to 80% (noncondensing) with

a maximum humidity gradation

of 10% per hour

Storage

5% to 95% (noncondensing)

Maximum vibration

Operating

0.26 G at 5–350 Hz for 15 min

Storage

1.54 G at 10–250 Hz for 15 min

Maximum shock

Operating

One shock pulse in the positive z axis

(one pulse on each side of the system) of

31 G for 2.6 ms in the operational orientation

Storage

Six consecutively executed shock pulses

in the positive and negative x, y, and z axes

(one pulse on each side of the system)

of 71 G for up to 2 ms

Altitude

Operating

–16 to 3048 m (–50 to 10,000 ft)

NOTE: For altitudes above 2950 ft,

the maximum operating temperature

is derated 1ºF/550 ft.

Storage

–16 to 10,600 m (–50 to 35,000 ft)

Airborne Contaminant Level

Class

G2 or lower as defined by ISA-S71.04-1985

Environmental (continued)

12 Getting Started With Your System

Dell™ PowerVault™

NX3100 系统

系统使用入门

管制型号 E13S 系列

注、小心和警告

注：“注”表示可以帮助您更好地使用计算机的重要信息。

小心：“小心”表示如果不遵循说明、就有可能损坏硬件或导致数据丢失。

警告：“警告”表示可能会造成财产损失、人身伤害甚至死亡。

____________________

本说明文件中的信息如有更改，恕不另行通知。

未经 Dell Inc. 书面许可，严禁以任何形式复制这些材料。

本文中使用的商标：Dell 、 DELL 徽标、

和 PowerVault 是 Dell Inc. 的商标； Intel 和 Xeon 是

Intel Corporation 在美国和其它国家 / 地区的商标或注册商标。 Microsoft 和 Windows 是

Microsoft Corporation 在美国和 / 或其它国家 / 地区的商标或注册商标。

本说明文件中述及的其它商标和产品名称是指拥有相应商标和产品名称的公司或其制造的产

品。 Dell Inc. 对其它公司的商标和产品名称不拥有任何所有权。

管制型号 E13S 系列

2010 年 2 月 P/N 50KNY 修订版 A00

系统使用入门 15

安装和配置

警告：执行下列步骤之前，请查看系统随附的安全说明。

打开系统包装

打开系统包装并确认各个组件。

遵循系统随附的安全说明和机架安装说明，在机架中组装滑轨并安装系

统。

16 系统使用入门

可选 - 连接键盘、鼠标和显示器

连接键盘、鼠标和显示器（可选）。

系统背面的连接器附有图标，指示要插入每个连接器的电缆。请确保拧紧

显示器电缆连接器上的螺钉

（如果有）。

连接电源电缆

将系统电源电缆连接至系统，如果使用显示器，则将显示器电源电缆连接

至显示器。

系统使用入门 17

固定电源电缆

如图所示，将系统电源电缆弯曲成一个环状，并使用所提供的腕带将其固

定到支架。将电源电缆的另一端插入接地的电源插座或单独的电源，如不

间断电源设备 (UPS) 或配电装置 (PDU)。

开启系统

按下系统和显示器的电源按钮。电源指示灯将会亮起。

18 系统使用入门

安装可选挡板

安装挡板（可选）。

支持的操作系统

系统预安装了 Microsoft

®

Windows

®

Storage Server 2008 (x64) 版本。

注 : 有关支持的操作系统的最新信息，请访问 support.dell.com。

可能需要的其他信息

警告：请参阅系统附带的安全与管制信息。保修信息可能包括在该说明文

件中，也可能作为单独的说明文件提供。

•

机架解决方案附随的机架说明文件介绍了如何将系统安装到机架中。

•

《硬件用户手册》提供了有关系统功能的信息，并说明了如何排除系统

故障以及安装或更换系统组件。可在

support.dell.com/manuals

在线获

取该说明文件。

•

系统随附的所有介质都提供了用于配置和管理系统的说明文件和工具，

包括与随系统购买的操作系统、系统管理软件、系统更新软件以及系

统组件相关的说明文件和工具。

注：请经常访问 support.dell.com/manuals 以获得更新，并首先阅读这些

更新，因为这些更新通常会取代其它说明文件中的信息。

ページを読み込んでいます...

Dell PowerVault NX3100 クイックスタートガイド

関連論文