产品图解
Fn:切换到蓝字符功能，同时Fn指示灯亮起；
再按一切换回默认功能，Fn指示灯熄灭。
WWW./.COM:快速输入WWW.与.COM字符。
红外功能及学习操作
空鼠功能
单击[空鼠]键开启空鼠功能，此时蓝
色闪烁一次灭。在空鼠状态下，随着
遥控器的移动，鼠标也会跟着相同的
方向移动，此时[确认]键变为鼠标左
键功能。再次单击[空鼠]键关闭空鼠
功能。
翻面禁止功能
为了防止按键误操作，遥控器在正常
使用中，只允许向上一面按键的功能，
向下一面的按键功能禁止输出。
CPI调整
CPI（鼠标指针移动速度）共分为4档，
分别为1、2、3、4档 ，默认 为第2档，
档位的数值越大空鼠的移动速度越快。
空鼠速度增快：按住[OK] 键 + [VOL+] 键
约3秒，工作指示灯闪烁两下后放开，
CPI在原来的基础上增加1档。
空鼠速度减慢：按住[OK] 键 + [VOL-] 键
约3秒，工作指示灯闪烁两下后放开，
CPI在原来的基础上减少1档。
遥控 器
充电器
(DC5V)
充电线说明
遥控器使用手册
指示灯说明
操作项目 指示灯状态
接收器离线状态 蓝灯慢速闪烁
接收器连接状态
按键单击 蓝灯闪烁一次
按键长按 蓝灯常亮
空鼠开启 蓝灯闪烁一次
对码 进入对码 蓝灯常亮
对码成功 蓝灯快闪3下后熄灭
电量提示
红灯常亮
红灯熄灭
低电 按键时蓝灯快闪3秒
充电
充满
支持系统：Android\Windows\Mac OS
\Linux
规格参数
无线调制方式：GFSK
调制频率：2.4~2.4835GHz
工作温度：-20℃~65℃
电池类型：300mAh/3.7V锂电池
整机功耗：9m A
待机功耗：25uA
按键数：57键
遥控距离：>10米
充电端口：Micro USB
外形尺寸：158×55×16.5MM
产品净重：86 .5±5g
配对方法
遥控器和USB接收器出厂时已经配对，所以
将接收器插后可直接使用。如在使用过程中
误操作或其它原因造成遥控器与接收器不能
正常连接通讯，可通过以下方法连接：
启动
配对
把接收器插入后,将遥控器靠近接收
器10CM内,同时按住遥控器上的
[VOL+]和[VOL-]键约 3 秒蓝灯常亮,
表示进入配对模式。
配对
成功 几秒钟后蓝色指示灯闪烁三次并熄
灭表示配对成功。
配对
失败 30秒内无法配对蓝色指示灯熄灭并
退出配对模式。
当遥控器连续15秒无任何操作时，
遥控器进入睡眠模式，指示灯熄
灭。
睡眠和唤醒
遥控器进入休眠后，按任意键可
唤醒遥控器进入正常工作状态。
工作指示灯
充电指示灯
电源
主页
返回
空鼠
菜单
确认、方向键
音量-、 音量+
.c om
ww w.
BACK
Fn指示 灯
USB充电 口
包装包含
1. 遥控 器 X1
2. USB接收器 X1
3. USB充电线 X1
4. 说明书 X1
注意
本产品使用内置锂电池，充电输入
电压为5V。
遥控器如果长时间没有使用或电量
不足时，请充满电后再使用。
使用指定USB线给遥控器充电，过度
充电将会缩短电池寿命。
避免在酷热或严寒的环境中使用，
这将缩短电池寿命。
本产品请远离液体使用，比如水。
123 4 5
Project Indicator led status
Separate status
with USB receiver Blue light flashing slowly
Connection status
with USB receiver
Click Button
Press Button
long time
Open the
air mouse
Pairing
Power
indication Low power
Charging
THANKS FOR READING
Air Mouse function:
CPI adjustment
CPI (mouse pointer movement speed) default second file
(CPI is divided into four files, respectively, 1,2,3,4 file),
the greater the value of the stall the faster the speed
of the mouse.
Increases the speed of the air mouse: press and hold the
[OK] key + [volume +] key for about 3 seconds, the work
indicator flashes twice and then releases the CPI on the
original basis increase of 1 file.
The mouse speed slow down: hold down the [OK] key +
[volume -] key for about 3 seconds, the work indicator
flashes twice after the release, CPI on the basis of the
original reduction of 1 file.
Auto sleep and wake up feature
When the remote control for 15 seconds
without any operation, the remote control
into sleep mode, blue light is off.
After the remote control entering
hibernation , press any key to wake up the
remote control to enter the normal
working condition.
Remote
Charger
(DC5V)
Charging line instructions
Air Mouse Use Manual
Picture Image
Led Indicator
Charging Indicator
Power ON/OFF
Air mouse Home
Confirm
/direction key
Menu Return
Volume+,Volume-
Fn Led indicator
Usb Charging port
Fn:switch to the blue character function, the indicator
light on, then press once to switch back to the default
function, the Indicator goes off.
WWW./.COM:quick input WWW. and .COM characters.
.c om
ww w.
BACK
Pairng Method
Air mouse and receiver has been paired , so the receiver
can be inserted after the automatic connection of the air
mouse, in the course of misuse or other causes of air mouse
and receiver can not connect the normal communication
can be connected through the following methods:Matching
operation is as follows:
When the remote control is not connected to the USB Dongle,
send infrared key values
a Take the power key as an example to illustrate the learning
b. Use the transmission window of the learned remote
controller to aim at the transmission window of this remote
infrared code value is cleared.
Note
Prohibit flip function
In order to prevent the wrong operation of the key, the air
mouse in normal use only allows the function of the button
on the side, the next button function to prohibit the output.
After inserting the receiver, close the air
mouse near the receiver (within 10CM),
then press and hold the [Volume +] button
and the [Volume -] button for about 3
seconds. The blue light flashes three times,
it means into the pairing mode.
Start
pairing
After a few seconds of pairing, the blue light
flashes three times to indicate that the
pairing is successful.
Pairing
Success
After the 30 seconds,the blue light flashes
three times and goes out,it means exits the
pairing mode.
Pairing
Failure
IR learning Function:
Led Indicator instructions
Blue light flashes once
Blue light flashes once
Blue light normally on
Enter pairing mode Blue light normally on
Pairing successed Blue light flashing 3
times quickly
Charging :Red light normally on
Full of charging: red light off
Press any buttons,the blue light
flashes 3 seconds quickly.
Specifications
Wireless modulation modeG FSK
Modulation frequency:2.4-2.4835GHZ
Working temperature:-20~ 65
Battery type: 300mah ,3.7 V lithium battery
Overall power consumption: less than 9mA
Standby power consumption: less than 25uA
Key number: 57keys
Remote control distance: 1 0 meters
Charging port:micro USB
Size: 158*55*16.5MM
Weight:About 86.5g±5g
Support system:Windows Android\Mac OS\Linux
Package contents
1. Air Mouse
2. USB Receive
3. USB charging cable
4. User Manual
Notice:
This product uses built-in lithium battery, charging
input voltage of 5V.
If the remote control is not used for a long time or when
the battery is low, please use it when it is fully charged.
Use the specified USB cable to charge the remote control,
overcharge the battery will shorten the battery life.
Avoid use in hot or cold environments, which will shorten
battery life.
123 4 5
140.00 mm
300.00 mm
遥控器没有与USB Dongle连接时，正面按
键为红外功能，才能正常使用红外学习功
能；当与USB Dongle连接后为2.4G功能，且
不能操作红外功能；[电源]键和学习以后的
按键始终发红外键值。
a、以电源键为例说明学习方法，长
按电源键，指示灯先快闪3次，
然后进入慢闪状态；
b、用被学习的遥控器发射窗对准本
遥控器的发射窗1-5CM距离学
习，按一下被学习遥控的电源
键，学习成功后指示灯快闪3次
后，自动保存码值且退出红外学
习模式；
c、如果要学习其他按键，就按照
a-b步骤操作即可；
d、同时长[OK]+[左键]5秒左右，
指示灯快闪3次，表示清除已经
学习的红外码值。
注意：当连接USB Dongle后发现有一
些按键没有功能，再使用此学习这些
按键。
-
1
