OP-R09HR-W
WIND SHIELD for R-09HR
This wind shield is for use with the R-09 audio recorder when it has been placed inside the
specially designed OP-R09C case (sold separately).
It is made of special material that allows sound to pass through while keeping wind out,
significantly reducing unwanted wind noise.
’
•
Main material
• Polyurethane
Use of this product with the R-09HR requires the optional OP-R09HR-C cover/stand set.
* In the interest of product improvement, the specifications and/or appearance of
this product are subject to change without prior notice.
*5100004373- 01*
Copyright ©2008 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without
the written permission of ROLAND CORPORATION.
Display
Opening
on the
back side
Opening
of the shield
Ring
Attaching the OP-R09HR-W
Fit the wind shield over the R-09HR with its cover (OP-R09HR-C) attached.
Push the wind shield onto the R-09HR so that
the opening of the shield coincides with
the display of the R-09HR.
If you're using a tripod or the mic stand
adapter (OP-R09M), attach it through
the opening on the back side.
Make sure that the ring does not reach
the inside of the wind shield.
Be sure to orient the wind shield correctly.
Placement
Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it
inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat
can deform or discolor the unit.
Important Notes
/