How to use Automatic Ice Maker
● Do not put anything, such as frozen food, ice cream other than ice in the ice box.
● Do not touch ice lever detector or ice tray with your hands, you may get injured.
Filling the pure water until the
“FULL” level then closed by cap.
2
1
Push the tank into the case
until it locked at the setting line.
Notice
● For a first installed, allow 24 hours for
the refrigerator to cool down and make ice.
Caution
Using the ice maker for the first time :
● Throw away the first full ice box of Ice cubes. Odor or dust may adhere on it.
● If water tank was dropped, make sure that water is not leaking from the tank.
● Do not fill other liquid, any beverages such as juice, cola, beer etc, into the water tank.
● Do not fill hot water into the tank (Tank Heat-resistance temperature : 50
o
C).
● Ice maker will stop automatically when
Ice box is full and it will start again
automatically when ice cubes in the ice box is
reducing or empty.
● It is normal that a noise is generated
when ice made or ice dropped into the ice box.
FULL
Ice trayIce scoop
Ice detection lever Ice cube box
(FRONT)
1. Remove the case from
the lid by turning it in the
direction as shown below.
2. While pressing the knob,
remove the water filter from
the bottom of the case.
3. Wash the water filter
with soft sponge.
● Do not use kitchen soap or bleaching agent.
● The water filter is form easily; therefore do not stab it with sharp stick.
* Service part no. : PTR-570ES4K 004
case
lid
knob
Water filter
Cleaning the Water Tank
Turning on/off the Automatic Ice Maker Function
water filter
lid
case
packing
●
As seen in the figure below, press the central front part of
t
he lid to lift it up.
(Do not open the lid by nails.)
●
To close the lid, make sure that the grips at the back are st ill holding the lid,
then close the lid down in the direction as shown below.
● If you do not intend to use the Automatic
Ice Maker, turn it off
First, check the Automatic Ice Maker is in operation.
Notice
1. When in operation. 2. To stop the operation, press
the “Ice Maker” button.
3. When restarting operation.
The lamp will turn on. The lamp will turn on.The lamp will turn off.
water supply cover
lid
grips
Malfunction Display
● *
1
The freezer compartment door
might not be closed properly.
●
Remove the obstacles if any, and confirm that the freezer
compartment door is closed properly. Then, wait for the inside
of the freezer compartment to cool sufficiently.
● Remove the obstacles if any, and confirm that the refrigerator
compartment door is closed properly. Then, wait for the insi
de
of the refrigerator compartment to cool sufficiently.
● *
1
The refrigerator compartment
door might not be closed properly.
Error Trouble Display Possible cause What to check
Light 3 sec.
Blink once
Light 3 sec.
Blink twice
blink time (n = 1~2)
3 Sec
0.25 Sec
0.25 Sec
[ Lighting 3 Sec + Blink ]
lighting
0.25 Sec
*1:This case is the door incomplete closing proceed from something caught between door and cabinet of refrigerator.
It is causing a gap betweem door and cabinet of refrigerator. And it cause tempereture rise in the refrigerator.
Water tank set line
water tank
ON
OFF
ON
OFF
ON
OFF
PiPi
Beep
8