[For U.S.A. and Canada]
THIS CLASS A DIGITAL DEVICE COMPLIES
WITH PART15 OF THE FCC RULES AND THE
CANADIAN
ICES-003. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT
MAY CAUSE UNDERSIGNED OPERATION.
CET APPAREIL NUMERIQUE DE LA CLASSE A
EST CONFORME A LA NORME NMB-003 DU
CANADA.
[ For EU and EFTA countries ]
CE Notice
Marking by the symbol CE indicates compliance
with the EMC directive of the European
Community. This marking shows conformity to the
following technical standards.
EN 55011 Group 1 Class A / 98 :
"Limits and methods of measurement of radio
disturbance characteristics of industrial, scientific
and medical (ISM) radio-frequency equipment"
EN 61000-6-2 / 99 :
"Electromagnetic compatibility (EMC) - Part 6-2 :
Generic standards - Immunity for industrial
environments"
For DC power-driven products to meet EN 61000-6-2 / 99,
the following operational conditions must be satisfied.
1. Input and output signal cable length : 30 m or less
2. Cable length for input power source : 10 m or less
3. Scale cable length : 30 m or less
Note
When using the same cable for output signal and input
power source, the cable must not be longer than 10 m.
For AC power-driven products to meet EN 61000-6-2 / 99,
the following operational conditions must be satisfied.
1. Input and output signal cable length : 30 m or less
2. Scale cable length : 30 m or less
Warning
When using this device with equipment governed
by Machine Directives EN 60204-1, measures
should be taken to ensure conformance with those
directives.
Warnung
Wenn dieses Gerät mit Ausrüstungsteilen
verwendet wird, die von den Maschinenrichtlinien
EN 60204-1 geregelt werden, müssen Maßnahmen
ergriffen werden, um eine Übereinstimmung mit
diesen Normen zu gewährleisten.