–1
(1) (2)
–2
(1)
(2)
FE
70
35
50
35
50
70
24
LOCK
FE
FE
3570
35
50
50
70
24
LOCK
GM
2.8/24-70
2
1
6
13
3
7
9 10 118
54
12
35
50
70
24
LOCK
LOCK
FE
70
35
50
電気製品は、安全のための注意事項を守ら
ないと、人身への危害や火災などの財産へ
の損害を与えることがあります。
使用上のご注意
フラッシュ使用時のご注意
周辺光量について
各部のなまえ
レンズの取り付けかた／取りはず
しかた
取り付けかた（イラスト
–
参照）
1
前後のレンズキャップとカメラのボディ
キャップをはずす。
2
レンズとカメラの白の点（マウント標点）を
合わせてはめ込み、レンズを軽くカメラに押
し当てながら、時計方向に「カチッ」とロック
がかかるまでゆっくり回す。
取りはずしかた（イラスト
–
参照）
カメラのレンズ取りはずしボタンを押したま
ま、レンズを反時計方向に回してはずす。
レンズフードを取り付ける
レンズフードの赤線をレンズの赤線（レンズ
フード指標）に合わせてはめ込み、レンズフード
の赤点とレンズの赤線が合って「カチッ」という
まで時計方向に回す。
取りはずしかた
レンズフードのフード取りはずしボタンを押し
ながら、反時計方向に回してはずす。
ズームする
ズームリングを回して、希望の焦点距離（ズーム
の位置）に合わせる。
ズームロックスイッチについて
ピントを合わせる
AF（オートフォーカス）／MF（マニュアル
フォーカス）の切り替え
レンズ側の設定
フォーカスモードスイッチを、AFまたはMFの
いずれか設定したいほうに合わせる（1）。
AF/MFコントロールボタンを装備したカメラをお
使いの場合
フォーカスホールドボタンを使用
する
主な仕様
商品名
（型名）
FE 24-70mm F2.8 GM
(SEL2470GM)
焦点距離（mm）
24-70
焦点距離イメージ*
1
（mm）
36-105
レンズ群一枚
13-18
画角1*
2
84°-34°
画角2*
2
61°-23°
商品名
（型名）
FE 24-70mm F2.8 GM
(SEL2470GM)
最短撮影距離*
3
（m）
0.38
最大撮影倍率（倍）
0.24
最小絞り
F22
フィルター径（mm）
82
外形寸法（最大径×長さ）
（約：mm）
87.6 × 136
質量（約：g）
886
手ブレ補正機能
This instruction manual explains how to use
lenses. Precautions common to all lenses such
as notes on use are found in the separate
“Precautions before using”. Be sure to read both
documents before using your lens.
This lens is designed for E-mount cameras. You
cannot use it on A-mount cameras.
The FE 24-70mm F2.8 GM is compatible with the
range of a 35mm format image sensor.
A camera equipped with a 35mm format image
sensor can also be set to shoot at APS-C size.
For details on how to set your camera, refer to its
instruction manual.
For further information on compatibility, visit the
web site of Sony in your area, or consult your dealer
of Sony or local authorized service facility of Sony.
Notes on Use
When carrying a camera with the lens attached,
always firmly hold both the camera and the lens.
Do not hold by the part of the lens that protrudes
when zooming.
This lens is not water-proof, although designed with
dust-proofness and splash-proofness in mind. If using
in the rain etc., keep water drops away from the lens.
Precautions on using a flash
When using a flash, always remove the lens hood and
shoot at least 1 m (3.3 feet) away from your subject.
With certain combinations of lens and flash, the lens
may partially block the light of the flash, resulting in a
shadow at the bottom of the picture.
Vignetting
When using the lens, the corners of the screen
become darker than the center. To reduce this
phenomena (called vignetting), close the aperture by
1 to 2 stops.
Identifying the Parts
1 Lens hood index
2 Focusing ring
3 Zooming ring
4 Zoom lock switch
5 Focal-length index
6 Lens contacts*
7 Focal-length scale
8 Lens hood
9 Hood release button
10 Focus hold button
11 Focus mode switch
12 Mounting index
13 Lens mount rubber ring
* Do not touch the lens contacts.
Attaching and Detaching the
Lens
To attach the lens
(See illustration
–
.)
1
R
emove the rear and front lens caps and
the camera body cap.
You can attach/detach the front lens cap in two
ways, (1) and (2). When you attach/detach the
lens cap with the lens hood attached, use method
(2).
2
Align the white index on the lens barrel
with the white index on the camera
(mounting index), then insert the lens
into the camera mount and rotate it
clockwise until it locks.
Do not press the lens release button on the
camera when mounting the lens.
Do not mount the lens at an angle.
To remove the lens
(See illustration
–
.)
While holding down the lens release
button on the camera, rotate the lens
counterclockwise until it stops, then detach
the lens.
4-576-640-02(1)
SEL2470GM
交換レンズ
Interchangeable Lens
Objectif interchangeable
取扱説明書
Operating Instructions
Mode d’emploi
Manual de instrucciones
E-mount
©2015 Sony Corporation
Printed in Thailand
Attaching the Lens Hood
It is recommended that you use a lens hood to
reduce flare and ensure maximum image quality.
Align the red line on the lens hood with the
red line on the lens (lens hood index), then
insert the lens hood into the lens mount and
rotate it clockwise until it clicks into place
and the red dot on the lens hood is aligned
with the red line on the lens.
If you do not rotate the lens hood until it clicks into
place, its shadow may appear in recorded images.
When using a built-in camera flash or an external
flash attached to the camera, remove the lens hood to
avoid blocking the flash light.
When storing, fit the lens hood onto the lens
backwards.
To remove the lens hood
While holding down the hood release button
on the lens hood, rotate the lens hood
counterclockwise.
Zooming
Rotate the zooming ring to the desired focal
length.
Zoom lock switch
This prevents the lens barrel from extending due to
the weight of the lens while it is being carried.
Before setting the zoom lock switch, fully return the
lens to W (wide).
Slide the zoom lock switch in the direction to lock
the zoom. To unlock the zoom, slide the zoom lock
switch back.
Focusing
The focus mode switch of this lens does not function
with some camera models.
For further information on compatibility, visit the web
site of Sony in your area, or consult your dealer of
Sony or local authorized service facility of Sony.
To switch AF (auto focus)/
MF(manual focus)
The focus mode can be switched between AF and
MF on the lens.
For AF photography, both the camera and lens
should be set to AF. For MF photography, either or
both the camera or lens should be set to MF.
To set the focus mode on the lens
Slide the focus mode switch to the
appropriate mode, AF or MF (1).
Refer to the camera manuals to set the focus mode of
the camera.
In MF, turn the focusing ring to adjust the focus (2)
while looking through the viewfinder, etc.
To use a camera equipped with an AF/MF
control button
By pressing the AF/MF control button during AF
operation, you can temporarily switch to MF.
Pressing the AF/MF control button during MF
operation lets you temporarily switch to AF if the lens
is set to AF and the camera to MF.
Using the Focus Hold Buttons
The focus hold button of this lens does not function
with some camera models.
For further information on compatibility, visit the web
site of Sony in your area, or consult your dealer of
Sony or local authorized service facility of Sony.
Press the focus hold button in AF to cancel AF.
The focus is fixed and you can release the shutter
on the fixed focus. Release the focus hold button
while pressing the shutter button halfway to start
AF again.
Specifications
Product name
(Model name)
FE 24-70mm F2.8 GM
(SEL2470GM)
Focal length (mm) 24-70
35mm equivalent
focal length*
1
(mm)
36-105
Lens groups-elements 13-18
Angle of view 1*
2
84°-34°
Angle of view 2*
2
61°-23°
Minimum focus*
3
(m (feet)) 0.38 (1.25)
Maximum magnification (X) 0.24
Minimum aperture f/22
Filter diameter (mm) 82
Dimensions (maximum
diameter × height)
(approx., mm (in.))
87.6 × 136
(3 1/2 × 5 3/8)
Mass (approx., g (oz)) 886 (31.3)
Shake compensation
function
No
*
1
This is the equivalent focal length in 35mm format
when mounted on an Interchangeable Lens Digital
Camera equipped with an APS-C sized image sensor.
*
2
Angle of view 1 is the value for 35mm cameras, and
angle of view 2 is the value for Interchangeable Lens
Digital Cameras equipped with an APS-C sized image
sensor.
*
3
Minimum focus is the distance from the image
sensor to the subject.
Depending on the lens mechanism, the focal length
may change with any change in shooting distance.
The focal lengths given above assume the lens is
focused at infinity.
Included items
(The number in parentheses indicates the number
of pieces.)
Lens (1), Front lens cap (1), Rear lens cap (1),
Lens hood (1), Lens case (1), Set of printed
documentation
Design and specifications are subject to change
without notice.
and are trademarks of Sony Corporation.
FE 24-70mm
F2.8 GM
